Hello RangerX,
I am trying to fiqure a way to install a 60/40 bench seat into my 91 Exp. They are hard to find used and very expensive new.

I think a Ranger truck seat will fit. Can you tell me what the lenght of your seat is and if the floor board is relatively flat?

Thanks,

DocMorro,
My seat measures 48" edge to edge, and ~40" mounting bolt to mounting bolt. I'm not sure what you would consider 'relatively flat'. I have a tranny hump going under the front of the seat. Can you be more specific?

------------------
Bill Collins
93 Ranger XLT 4X4
Modified

Thanks, My Explorer has about a 4" high Trans hump and the seat is about 48" wide. There is about 52" from door to door. I think I will get a seat from a late model Ranger and fabricate the mounts as planned.

Thanks,