I have read all the threads on keyless remotes and where the reset module is located but nobody seemed to ask my questions, so here I go.

I have a '95 LTD, I looked inside the jack compartment and this is what I see.

Directly to the right of the wiper bottle and almost touching it is a black box type object with what looks like two or more pin plugs, to the right of this box is a gray box that is secured with metal clamps. There are two multi pin plugs and what looks like an antenna wire coming out of it. Now to the left and above the wiper bottle is the connector for the rear locking switch that can open all locks and close all locks. Just below that is the air ride switch. I hope that explains the area well enough. I cannot find the knuckle or pen sized connector with two prongs. the only thing that looks about the size shape and diameter of a knuckle or pen is the wire that has an antenna connector on it.

Any help would be appreciated.

you really cant see it without taking the plastic molding off or pulling it back and shining a flashlight. its on the side tward the plastic interior. Hope this helps

I used a dental mirror those little sticks with a round mirror at the end and a flashlight took about 15 seconds.

I just pryed it back with my hands and shined it with a flashlight.

Ok guys,
I know you know what you're talking about and I appreciate it, but you lost me. You just pried what back and where, and what plastic molding. On the gray or black box. I'm so confused.

When you undo the jack compartment, look to the right inside the area where the jack is. Look towards the front of the car while shining a flashlight. You'll see the number somewhere in the area where it meets the rear seats. If you don't get it, I'm gonig to make a nother SoCo and coke.

I took the jack out still no connector

it should be written on the top of the computer/ module that is located in the jack compartment....look on the top of the module box.....that is where the ### are located.....peace out

OK, I decided to take the small screw out of the metal clamp holding the gray box. Then I bent the box down and was able to read the label. remote keyless entry (RAP). it had the door keypad code which I already knew plus 3 long sets of numbers. the #'s are
F57F-15K602-AC
FCCID KMH-15K602-RAP A
950209

I hope I'm getting closer to the problem, any help guys ?

You all made me look like Mr. Fixit with the other help, and everything has worked. But I still can't get the keyless remotes to work. Could the connector I am looking for be under all the tape around the wires in the jack panel ? Please Help.

5 digits