i took the front rims and tires off my 93 switched to my 95, when i tried the back the rim wont pop off Are there any tricks or could it be stuck that bad? Thanks alot about to go try again yankin away lol

Get a hammer and smack the back side of the tire & rim.. sometimes condensation between the rotor & rim will cause it to stick together.

:confused: LMAO. It's just stuck. Use a block of wood against the rim,and pound the shit out of it with a sledge hammer.

hey thanks i thought there may be something else that needed to come off , but its just the lugs huh. noticed the rotors are in very very bad shape maybe has something to do with it. fronts have been done but not the rear. Thanks

Just give it a nice little kick, it should pop right off!

I've had to pund the sh*t out of wheel one time because it wouldn't come off. You shouldn't harm anything - unless you can't swing!

-Drew

lol i can sing carpenter by trade and speakin of i just came in from swingin kickin pullin and punchin but nothing almost knocked the jack over so i wd it and will try again in the morning. also do you think iy matters that im taking off 16x7 rims and replacing with 15x7 because they had my new bf's on em tire diameter and with about the same? thanks

i threw a brick at mine (spare) popped right off

putting 16s on instead of 15s will be of no issue.... you must remove the lugnuts before you try to get the wheel off..... also, using words with all their letters in them helps out a lot, so do punctuation marks

If you don't have a hammer, take off the lugs and drive it. They will come off. :rolleyes: