Where have you mounted your compressor? and have you had any problems with water or mud getting into it? please post some pic if you have them.
I was thinnking of mounting mine between the master cylinder and washer resovoir. I have a seperate comprssor for filling tires.

Bump for ya.

That was so nice of you Bill!

You can see mine here:
http://www.explorerforum.com/data/500/2893driverdetail.jpg
Sorry its not he best picture, but you can see the top of it.


Nice thing about this position is it gets cooled by incoming air through the rad support and a little bit by the fan.
I drilled the holes int he rad support and used the supplied plate on the grill side, you can see the plate in the bottom right of this pic, and see how it gets cooled there:
http://www.explorerforum.com/data/500/2893shroudmount.jpg
(cooled by air coming through the hole above the plate.


Plus its easily accessable for airing up (I have a chuck on mine, works ok but I usually just drive home aired down)

Maybe I can get a picture of the compressor itself someday instead of jsut everything around it
:)

410Fortune- Thanks, do you ever have problems with deep water etc..? we have lots of muds and water here in WA

How much air do those pumps make? I bought a 12V Puma compressor to locate in my 99 chassis. I'm going to have to locate it in three pieces, but it makes 3.4cfm at 90psi.
Don

Here is where I put my ARB compressor

http://www.fototime.com/ftweb/bin/ft.dll/standard?pictid={83D2F049-36C9-4BF3-89E6-C93B0413A7FB}

I ended up build a small bracket and mounted it similar to 410

I can take a pic and post it tomorrow for ya of my setup.

Hello Joe, where did that cover come from? I have a plan to mount mine in the right rear window, face up like that, and a cover would be a good idea.

The cap on the quick disconnect is off a hyd. fittiing I found at work. I also have a large round piece soft plastic that i am going to put over the top of compressor.here is the northwest we see alot of mud and rain and I don't want the compressor to take a direct hit.

I understand. My 12V compressor is too large to go under the hood. I'll be mounting mine on the frame, behind the left tire. I plan to make an aluminum cover to keep the tire from throwing mud on it. Regards,