You are viewing the Serious Explorations Archive.
Click Here to view our message board.


View Full Version : P0193 - Fuel rail pressure sensor circuit high input


yeahmen
12-12-2007, 04:40 PM
I keep getting this code. I would reset with my OBD II Scanner and it would still appear. Can some one guide me in the right direction as what i may need to check and repair/replace. I have a sport trac 2004 XLS.

Thanks

MountaineerGreen
12-12-2007, 04:44 PM
Sounds like your fuel pressure regulator or whatever your truck uses to regulate fuel pressure is messed up, or the sending unit is bad. Clearing the code won't work- you have a problem that needs to be fixed. I think yours uses a returnless fuel system, so the pump and regulator may be all the same thing :dunno:

The best thing to do is get a fuel pressure gauge, connect it to your rail and see what your fuel pressure is.

cjones101812
12-16-2007, 12:37 AM
is this a flex fuel vehicle?? VIN code K

if so, with scanner connected, Key ON Engine RUN, is pressure above 119.9 psi??

yeahmen
12-17-2007, 02:23 PM
The vehicle's engine type is 4.0L V6 FI SOHC. Don't know if that information will be helpful. The eighth character in the VIN is a K.

cjones101812
12-17-2007, 02:45 PM
according to my book, vin X is the 4.0L FlexFuel engine.

are you running gasoline or natural gas??

assuming you are running gasoline...

check for fuel in the vacuum hose of the FRP sensor after running engine at idle for 2 minutes. if not, check fuel pressure.

if pressure good, check voltage between Sensor connector Vref (Pin#3 LB)and Signal Return (Pin#4 GY/RD) should be 4.0-5.5v with key ON.