|
View Full Version : 1994 ford ranger...runs poor when warms up. mark7164 06-09-2009, 09:20 PM Hi...maybe someone can help? I have a 94 ranger 4 cyl....if i start in the morning it runs great till it warms up after driving about 5 mins.... it begins to stall,backfire and lose power.... it wont stay running. It has to fully cool down to run well again only to start up again. It must sit for hours sometimes for it to not act up on start up....any ideas? thanks Tbars4 06-09-2009, 09:58 PM ...Have you had your codes checked???..This might help find some answers even if you don't have a CEL... ..It could also be a cat problem but with as little information as you have given, I would start with checking for codes... mark7164 06-11-2009, 04:50 PM I did pull of the spark plug wires from the coil and only 2 showed spark from the coil out of the 4. the other coil all had spark. I do need to get the codes checked but to get it to the shop is a pain. Tbars4 06-11-2009, 04:58 PM ..Get a paperclip and click on the link in the first post of this thread...;) http://www.explorerforum.com/forums/showthread.php?t=147734 mark7164 06-11-2009, 07:49 PM 159,158,157,335 ,222,224 Tbars4 06-11-2009, 08:24 PM ..:bounce:...Woo hoo....You hit a jackpot...:D 157(R,M)Mass Air Flow signal is/was low or grounded - MAF 158(O,R,M)MAF sensor is/was high or short to power - MAF 159(O,R)MAF sensor is/was out of range - MAF 222(M)IDM open or high or right coil pack failure - Ignition Systems 224(M)Failure in ignition coil primary circuit - Ignition Systems 335(O)EGR feedback signal is/was out of range - EVR or PFE ...The first thing I would do is see if my MAF was plugged in...:scratch:...I would look at the plug circled in green... http://i251.photobucket.com/albums/gg318/doolok/Explorer/40liter2.jpg mark7164 06-12-2009, 03:47 PM ..:bounce:...Woo hoo....You hit a jackpot...:D 157(R,M)Mass Air Flow signal is/was low or grounded - MAF 158(O,R,M)MAF sensor is/was high or short to power - MAF 159(O,R)MAF sensor is/was out of range - MAF 222(M)IDM open or high or right coil pack failure - Ignition Systems 224(M)Failure in ignition coil primary circuit - Ignition Systems 335(O)EGR feedback signal is/was out of range - EVR or PFE ...The first thing I would do is see if my MAF was plugged in...:scratch:...I would look at the plug circled in green... http://i251.photobucket.com/albums/gg318/doolok/Explorer/40liter2.jpg thank you so much for your help! I fixed it today ....it was the ICM. I did do the coil and still no spark. The code went away about the maf..i just cleaned that.I was left with 2 codes 223,224. No codes at all now! Tbars4 06-12-2009, 04:48 PM ...I am glad I was able to help...Congrats on having fixed your problem..:biggthump ...Be sure to add your location next to your name so others in your area might help also...;) |