1992 XLT
Well, I think I was second on this board to swap a 44 under my rig, behind Rick.
'79 Bronco Dana 44:
- housing cut 6" - pulled out longside tube from outer, cut 6" and press back on and weld
- axle shaft cut 6" at LeJeune engineering in Victoria, BC - cut, tapered, and tig welded in the middle of the shaft - no problems
- tierod cut down 6" and rethreaded
- drag link cut and threaded to accept my Dana 35 TRE and adjusting sleeve - Dana 35 TRE used at pitman arm
- coil buckets modified to accept James Duff 3.5" VR coils for EB
- stock radius arms
- '79 Bronco radius arm brackets
- new Dutchman 1541 Alloy rear shafts for my 8.8" for 5 on 5.5" bolt pattern
new this week:
- '79 housing cut down 3"
- BC Bronco...