Performance Lighting | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

Performance Lighting

Aftermarket lighting. Driving lights, fog lights, rock lights, HID, halogen. Make your Ford Explorer light up the night!!
How to: Install signal mirrors on 3rd gen Explorer How to: Activate fog lights with parking lights List of members with projector headlight retrofits How to: Brighter headlights on first generation Explorer HID projection and fog light conversion 2001 Fog Lamp Modification Puddle lights Keyless entry keypad color change How to: 91 - 94 Headlight and corner light swap Lighting FAQ and Answers Cure for rapidly flashing turn signals after installing LED lights H.I.D. simulating bulb test and review How to: Adding auxiliary offroad lights High mount brake light LED conversion How to: Smoked tail light tint Bumper mount light bracket Resistor identification chart - for LED lighting etc.
I have a 2012 Explorer limited that came with the factory HIDs, I was in the mountains this week driving down some very dark roads and I was really struggling to see as the lights seemed very dim even (I ended up following an F150 most of the way home as it headlights were way better) I had LEDs on my old truck and have HIDs in my other car and both seen way brighter, just wondering if there is an upgraded HID bulb available or even an LED conversion kit maybe?
I keep bursting bulbs in the passenger side fog lights. I make sure that they are clean of any oil/grease. After a couple of bursts, the inside of the lens is fogged! :eek: Is there a simple test that someone can 'hip' me to to understand this electrical magic? Thanks, Derek
I was attempting to change the bulb in my passenger door and it dropped down into the interior of the door panel. I can see the glow down there, but can't figure out how to get at it. I'm pretty much a newbie so I'm hoping one of you "experts" out there can give me a solution. Thanks
Hey guys, I want to replace my Headlights in my 15 Sport, with LEDs or HIDs, anyone have any thoughts on what the best lights are, brightness wise, and fitment wise??? Also The rubber flange on the back of the housing, will removing this give me moisture inside the assembly??? Any thought/advice greatly appreciated!! Thanks
Back
Top