I went to get my exhaust done today at my friend Jeff's shop...Karns Automotive in Groton, CT.
His tech Charles did most of the fab work, then Jeff helped line up and space the 2 exits for the final welds. These guys are just as picky as I am as far as the end of the tailpipes being
exactly the same on both sides.
I of course took some pics...
...first cut in getting the factory exhaust off...
...stock system in 3 pieces now...
...tacking the muffler in place...
...the muffler welded in it's final spot...
...muffler exit pipes...
...got 2 pipes poking up through there!...we had to use 2.25" pipe to go over the axle, two 2.5" pipes would not fit there comfortably...from this point it went back to 2.5" for the tailpipes...
...fitting the right side tail...
...working on the left tail...
...we ended up having to make the left tail 2 pieces, the bends were very close together and this was the only way to have a nice, smooth tailpipe...
...pretty much done, just need paint!...