Recent content by 91Rustbucket

I had a similar problem a few years ago and it was the fuel pressure regulator. Which was like a $50 fix and pretty easy.

Here's an overall view of what I'm looking at. The red is the line that Rick showed in his pic, the one I seem to be missing. What I need to know is where the connections are for it as this vehicle had A/C prior and I know I didn't cut the loom out but must have just disconnected it. The dark...

Still trying to perform some automotive archeology for this project, and it looks like I'm missing the chunk out of my wiring loom that connects to the compressor and to the accumulator (the piece you're holding here). I have 3 connectors over on the passenger side that don't go to anything...

I had a similar problem but mine turned out to be a short in the headlight switch, the headlights worked fine but no other lights. Probably not common, but something to take a look at if all else fails.

Since I'm replacing everything for the A/C system, how can I make sure I order all new compatible stuff? The only thing I bought that references years is the A/C Receiver Drier / Accumulator which is (From 03/1991), but nothing else says anything about a need for compatible years.

Thanks Rick, That looks like a pretty big wire loom that heads to the passenger side firewall area, hard wired into the loom or are there connectors there. I have a couple of connectors hanging out on that left side, but no big wire loom so I'm wondering if I'm doomed.

Hey guys, I'm working at reinstalling my A/C system after I ripped it all out about 6 years ago (long story), and I think I have all of the parts I need, BUT I can't find the A/C Compressor connector. Odds are I pushed it out of the way or zip-tied it to another connector to keep it from getting...

Thanks for the info Massacre, I fiddled with it for quite awhile before I finally came to a solution which I'll write out here incase anyone else has this happen to them. The two side gears wouldn't rotate with the S-spring in place so I carefully knocked the spring out with a brass punch and...

Mid-job on my rear axle shaft replacement on my 91X and the spider gears fell out. I was using my impact to try to pull the new wheel studs through the newly installed axle and it looks like the S-spring shifted a bit and the spider gears slipped out. I have the spacers and know which one was on...

Thanks for the hint! I just sent a message

About 6 years ago I ripped out my old non-functioning AC system that had been sitting empty for 15 years and swapped in a couple of ranger parts to make it heat only. At the time I lived in a cold wet place and never envisioned needing AC. Fast-forward to the present and I find myself living in...

Welcome LMC Truck and Rock Auto are pretty good starting points for stock body parts

LMC Truck is pretty great, with some excellent parts break down diagrams. Rock auto is always decent 1A auto has supplied me with a few hard to find parts JCWhitney then any of your stores that sell aftermarket stuff you can find some things

What do you mean when you say you "cut & turned beams"?

Any chance you have e-brake rub?