robinfla
New Member
- Joined
- September 26, 2010
- Messages
- 3
- Reaction score
- 1
- City, State
- Seminole Florida
- Year, Model & Trim Level
- 2000 Mountaineer
Blower motor gets power as soon as ignition is in on position and motor not running. Even runs with relay removed. Remove fuse 2 and it doesn't run. Works properly if I switch A/C on. I have replaced EATC with a known good one that I keep for testing. I know it is always hot from fuse and then supposed to go to relay from EATC. I'm guessing maybe a short, but can't guess where it is. I have disconnected power connector at blower and get 12v to it from the resistor side. Basically just need another opinion as to where to go from here before I start tracing wires and disassembling things.