Search results

Thanks for your input as well, Chikar. Short of dealer visit what recourse is there? Circuit tracing - not a strong point and manuals not bog on circuit diagrams. Any other possibilities? Drove fine until battery change....

Blee1099, thanks for your reply. Any remedy suggestion (s) to try?

Theft light will flash 6 times in succession, pause, flash once, pause, then repeat. The light will then disappear bit still no start

What is "wet ingression"? PCM module? Possible thatbattery terminal posts changes caused pats trigger?

1) The "theft" light (indicator) on the dash flashes fast when the key is in the ON position. The engine turns over & no fuel is getting to the engine (as though the fuel has been disabled {by the PATS being ON?} 2) Only have one key at purchase so no, I have yet to try any other(s). Thanks...

Should read "do to reset factory anti-theft?" Truck ran fine. Disconnected battery to change post terminals. plugs, wires. Assembled all & ...nothing. Just turns over. Could it be anti theft because dash light keeps blinking. Help!

The inertia switch didn't 'pop up'. Is there something else to tth to reset ?

Any other suggestions? Also no fuel going to engine...