Search results

OK i know that a 302 and 5 speed is going to be a better option but im getting my hands on a 289 for $free.99 and i can find an np435 for cheap too. My question is does anyone currently run a small block in the 1st gen b2/ranger? Im sure i could figure out getting the 289 in there just fine but...

I recently picked up an 88 bronco ii that the P.O. swapped a 4.0 into. It was a pretty clean swap and everything is working like it should, except for the tach. It reads about 1300 at idle. It is idling at a normal spot it's just the tach is off. The tach rises and falls with the engine just...

I just picked up 2 dana 44 High pinions and ive got a question. They both need some parts rebuilt on it. The one has a problem with the pinion not engaging on the ring and the other is missing the passenger side axle shaft and has drum brakes. So my question is can I take D44 ttb parts and slap...

Sp I picked up a 66-77 bronco dana 30 for $free.99 and it's got most of the goodies there. Radius arms, coils, steering... but it needs an axle shaft and everything from the steering knuckles out. My biggest question is can I use xj d30 parts and slap them on my EB d30? This will be going under...

So I went and bought a rough country 4 inch lift for a ranger knowing that I'd be doing a SOA in the rear. Well everything turned out great, except for one thing. The pitman arm. The one that came in the kit rear f150/bronco on the side so I was skeptical. But being just ready to wheel I slapped...

After finishing my lift I made a mistake. So my origional axles came with an open rear diff and 3.27 gears. Lame. So I bought a parts truck for a song and it came with 3.73s and a limited slip rear end. So I swapped them over while lifting the truck and did a pretty nice soa swap. Well me...

Hey, guys, so ive been doing some pipe dreaming. Who here has rhino lined the entire floor plan of their daily driver? Is there a big difference in noise? How does it fair in the winter, does it make it a lot colder in the cab now? And also how much does it cost for front to back? If youve got...

Hey, Gurus, I might have an opportunity to pick up a 99 ex with a 5.0 in it for cheap. Are these 5.0s roller motors? and is this a pretty straight foward(for the most part) swap into a first gen explorer? And what manual trans/t-case would you recommend for the swap? Thanks in advance.

So I recently joined the explorer fan club and bought my first x 3 months ago. First off its a 92, xl, 4.0 ohv, 5 speed, 4 door and 4x4. This truck has the option of power nothing and I love it. When I bought it the ladies said that the tires needed replaced and they just didn't have the time or...