Search results

99 ohv intake engine bay wiring for 99 first gen gauge with tac f-150 lift seat washer etc for cheap front spring lift new rear shoes drums an wheel cly for first gen sun roof cover 1991 set of heads were on trk should be ok but ive never had a shop check them ohv one...

hi im looking to fill in those factory holes on my rocker panel ,they seem to be 5/16 round . any company make or punch out sheet metal i cant seem to find any an im not looking forward to hand snipping an grinding my own got over 25 of them on my 4 door that need patching...

hi just wanted some info on my trim an side steps even if i dont place them back on the trk when im done cleaning up some rust. pics below were the brackets i have hear stock ?? my guess is no ive looked at some in the bone yards up here an they are all L shaped. but when i look at the...

heres what im picking up later on at the end of sept 08 :D 1996 v-8 with the awd engine runs great sounds like it only has 80 thousand on it not the 161000 the dash says its had lots of money thrown into from its previous owner an im getting it almost for a song . no radio possible transfer case...

watched power block show the other day an they blasted the underside of one of their rigs with soda . an from what they said it holds of the rust for awhile till you can paint undercoat whatever , my qwestion is i looked on a auto body site as i guess i need a different nozel for my sand...

im a few days away from pking up a used 96 awd with the v-8 . for short money it has transfer case problems . do i fix that #4404 case or try an go with the manual shifted umm 1998 case as some have done. i dont need to plow with it but id like to retire my old dodge an have one less trk...

pked this up in the metal pile at my local dump a few weeks back only numbers are on the mounting bracket nothing i can see on the step itself. any one know what it fits ? full size rig # is ford yl34-16470-davv grr id post a pick but seems im over my limit ok now i have pics...

i have a chance to buy a 2000 model yr engine already out of trk for 75 $. seems like a very good deal . what do you all thk ? should i go ahead an use this an upgrade my 91 to obd II or just swap my intake on this an throw it in ?? just wanting some opions any thing bad about this...

got a problem with my linc town car 2nd time in last few months its done this . 1993 model have all lights inside an out no dimming when key is turned but the last half inch of the turn of key were ud expect the starter to kick in dash lights go out an nothing happens . my first fix...

had my transmission out an figured now was a good a time as any to pull my pump an sending unit from tank. ive only had the used one i got from a bone yard for a yr an a half lol :) as expected brass float in mine had a hole an is paper thin surprized they could even make it outa the...

after many delays my 5 speed manual trans is out ill post some pics later. one question i have is theirs a bit of play ( side to side ) after taking slave spring an hyro off the shaft. how much is to much ?? im just thinking i should have none at all if i need a bearing should i buy...

well i have 1991 navaho with a 5 speed . i have 2 problems maybe related maybe not . its been going on now for 5 months before i explain further i can do many repairs but electrical trouble shooting isnt one of them. you could have a good battery in your hand give it to me an it would...

hi people im going to do my clutch change soon an wondered if any one has used a polly type transmission support before ? ive looked on a few sites an all i see is ones for a mustang listed pictures look similar to whats on my 91 5 speed but maybe ill have to call energy...

:eek: just picked up some brand new air bags to go into the front coils on my navahoooo got a great deal on e-bay got 2 sets for 32 bucks right to my door ford nos parts any one have them installed on theirs ?? ur opions howed they work for u ?? will post pics...