gen

I found these fender flares on eBay and ordered a set of 4 for $70. They’re polished steel and seem to be well made. They’re attached with screws and even have a rubber gasket. I’ll be painting them black and installing them this weekend and will post photos when I’m done. They don’t seem to...

I’ve been wondering how feasible it would be to install a cabin air filter in a second gen. I see that the door goes up and closes off the highlighted area when Max AC is selected, so that must mean that’s where outside air is pulled in. I don’t have ac diagrams and have never taken apart...

I was replacing the fan clutch on my Explorer and decided to go ahead and replace the serpentine belt. After I got everything out, I realized that the idler pulley, which is on my serpentine belt diagram under the hood, is non-existent. I'm not immediately worried, since I've been driving around...

I have a 2004 Eddie Bauer 2WD Explorer with a 4.6L V8. It has 206k on the clock. It has been a joy to drive and I've taken it on a lot of long, long road trips. I've also been pretty careful on the maintenance. There is one problem that is common with this vehicle, that I was afraid I would...

Hi, does anyone know what the battery cable size is on second gens? I'm trying to add compression lugs and I see they fit 2/0 gauge cable. I've looked everywhere but can't find this info. Thanks for any help. For anyone who has this question in the future. I went ahead and purchased the 2/0...

Hey Explorerforum. I've been on this site for a while now and it's helped me out a lot over the years, so I'm happy that I can contribute something in return. I've always wanted to post a "How To" thread, so here it goes. A while back I considered buying and installing aftermarket parking...

how do I find out what gen my explorer is. I keep hearing people talk about it. my explorer was an old cop car so getting any info on it is almost impossible but I am slowly starting to get it back together but it I have used just about trick I know this site has been a life saver

Done

Installed in assembly

Hose Beveled

Bulbs In

Hose Installed

Hose Size

Tools Needed

Well, after the testing, the next projects will definately be: rear bumper, lockers, and bead locks.

Four t-20 torx head screws secure the voltage regulator to the back of the regulator. It is possible to remove the regulator and brushes without removing the alt. But it is a pain and the chance of dropping a part into the housing is great.

Good clean pic of my explorer. Sas Conversion. 37" Super Swampers.