sensor

Hi I have a 2017 i purchased 2nd hand. Whenever I shift in reverse the loud beeping sounds, and everyone knows i have arrived. I have checked the manual, dash guide, and youtube and no answers. I wish to turn it off! I have tried pulling various fuses, especially ones related to towing, no...

I recently picked up this 03 Explorer with the 4.6L in it, the odometer says roughly 198k. I bought it pretty cheap so I've been fixing things and sorting out the bugs. Up until now the fixing has all been mechanical, bearing assy's, upper control arms, latches, hinges, etc. Here's the deal...

Good Morning, I have 2006 Explorer 4.6 (Limited), it has been in the family since it was brand new and well maintained. It has been driven very easily as only a commuter vehicle and has never had any mechanical issues. Lately though, the Engine Oil Temperature sensor code (P0197) has been...

Hello everyone and greetings from El Salvador. Recently I bought a 17 Explorer XLT on copart with a front end damage and exported to my country. I'm trying to find a three line sensor/module that goes on the lower part on the front bumper/radiator support. I went to the dealership and they...

2000 Ford Explorer, just changed the fuel pump and fuel filter about a month ago, and now we have another issue... Door ajar light interior lights and mirror lights are all staying on and killing my battery. Well I've tried Wd40, I've tried replacing the fuses that correspond with them, and...

Hey Guys, I am brand new to the Explorer community. I’ve really loved reading through all the posts on here. I’m excited to be part of the forum. I am looking to add a bull bar to my 2020 Platinum but want to avoid compromising the sensors on the front of the truck. Has anyone found one? I’ve...

2000 Explorer XLT 2WD 4.0L SOHC JOB1 5-Speed Automatic 5R55E. Can someone confirm the following? Thanks. The EGR system uses a EGR Pressure Sensor... not a EGR Temperature Sensor, right?

Does the 4WD 5R55E deep pan bolt on to the 2WD 5R55E? I want to add a transmission fluid temperature sensor the next time I change my fluid. Any issues if I switch over to the deeper pan? I know I’ll have to use a longer filter too. I plan to use a pan with a drain bolt like this: Then...

I am looking to replace a bad ABS sensor in my rear differential housing, I did a resistance test on the sensor and it proved to be open. The problem is the bolt head is completely rounded. I tried to cut a groove into the middle of it for a flat head screwdriver, but it ended up breaking half...

A couple of years ago I got the idea of replacing my throttle position sensor since it was the stock part. I gave up after rounding the philips screws. I then tired to use a dremel to cut a slot into the screw heads but that didn’t work out too well. Recently, my absolute throttle position...

Hello Everybody. New member here. Texas, USA. *2007 XLT 2WD* So a nail went in my tire and damaged the tire pressure sensor and they are expensive to have replaced. Can i just pull the module that controls this or what? Thanks in advance for money saving suggestions.

Hi guys, My check engine light is on and it says I have a problem with the O2 sensor. Does anyone know where the sensor is? Specifically the downstream one. Or any other things to look at? Thanks! P013A O2 Sensor Slow Response - Rich to Lean (Bank 1 Sensor 2)

I recently had my ABS sensor go out on my '98 4WD, front left wheel. No ABS light but it exhibited the typical activation of ABS when slowing down to a stop around 5 MPH. I put a new ABS sensor in and haven't had the ABS activate since, but while doing that I noticed something. Looking down...

I’ve read threads on this site about the tps and it seems that 19.6% is the normal position for the TPS at idle. Mine has recently started dropping to 19.2% at times and I’m getting erratic rpms lately, like a 30-50 rpm change every second. The truck runs really smooth and the rpms stay steady...

I replaced my coolant sensors almost a year ago and I’m worried I have them backwards. I’m using the dy-1144 sensor to control the gauge on the drivers side one wire connector, and the SW5174 fan switch for the computer sensor on the passenger side two wire connector. Any experts here that can...

Anyone here familiar with “normal” voltages for O2 sensors? Two of my sensors appear to be functioning correctly and are on opposite voltages. I’ve read before that it should be that way. However, the third sensor on bank 2/3 stays steady around .790 volts. Any idea if that’s bad? I appreciate...

so i was driving the other day to use my buddies code reader and plugged it in and it read "1483 brake petal input circuit fault" didnt think any thing of it until last night i went to hit the break and the pedal would not move, like locked up firm which also made the brakes basically...

Hey yall... so I have a 2008 Mercury Mountaineer with 180k miles on it. She runs GREAT! But this "Check fuel inlet" message that keeps showing up on my dash board every time it rains, is driving me insane. Does anyone know how to make it stop? Ive tried cleaning it out and all but it still does...

I will be checking my coolant sender and gauge sensor soon and I'm trying to find the resistance values for them but am having no luck. Anyone know the values for these? It's for a 03 ST

When I first got my used '05 Explorer this weekend, there was a message that said "Check tire pressure" or something like that. I stopped at the gas station on my way home and pumped up all of the tires to 36PSI. Instantly after doing this, the message changed to "Tire Pressure Sensor Fault"...

The car: 2005 2WD 4.0 automatic with about 110K miles on it. The symptoms: Check Engine light comes back on within 20-40 miles of being reset P0193 code (fuel pressure sensor high) Poor gas millage, around 12 MPG (was about 18 MPG a year ago) Occasionally runs slightly rough, mainly at idle We...

I have performed a swap from a 5R55W Auto Transmission (Stock 2006 Ford Explorer Auto) to a M05D-R1HD Manual (From Ford Ranger). The new manual transmission has a VSS in the tail housing has 12-holes. The stock OSS from my auto had 24-holes. I've adjusted the "number of holes in OSS" in my SCT...

I didn't even know the second gens had this option. I'm guessing it isn't just plug and play. Has anyone swapped one of these into their X? I personally wouldn't pay this much for a used bumper. But my local junkyard usually has 10-15 explorers, so I'm sure I'll find one of these eventually. I'm...

Vehicle info; 1997 (Production Date 02/97) Ford Explorer Sport 2dr, 4.0l SOHC. 4WD 5R55E Trans with auto transfer case Ok, So thought I got the same thing as was in my truck, but upon close inspection today when went to swap my 2 speed sensors over to my replacement trans (original ones...

Was changing my tie rod ends today and looked up while doing so. Noticed that my windshield washer fluid resevoir has a sensor plugged into the bottom. However my 2004 Ford Explorer XLS, doesn't have the message center, what's the purpose of the sensor. Thanks in advance for once again answering...