1991 Ford Ranger 2.3L 4 cylinder will not fire

[Vennessa]

A little over a week ago my truck shut off while I was going down the road and has not started since. It will turn over but will not crank. I have replaced the ignition module because I was told that is a common problem in this truck,but had no results.I then replaced the coil pack,the computer and he crank sensor.Still nothing.The only result was with the crank sensor,when it was replaced it finally started up twice,thought everything was ok,then after putting everything back again it will not crank! I'm at a loss any advice would be greatly appreciated. I'm out of ideas and money. Thank you

 

[boominXplorer]

Pull the cover and make sure the timing belt didn't snap

 

[Vennessa]

Pull the cover and make sure the timing belt didn't snap

Checked it and it looked good. I was told it could in the ignition switch, is this a possibility?

 

[Josh P]

Good fuel pressure?