The project was MUCH easier than I expected. The back took my friend and I less than an hour for both sides from start to finish. The front took about two hours. Heres the process as best as I recall. Remove rear tire Remove top and bottom stabilizer bolts....holds short 6" rod Remove shock bolt Remove lower control arm bolt Remove Spring Reverse process Remove front tire Remove upper swaybar bolt Remove both lower strut bolts....after removing nut....punch bolt out as it is splined and pressed in. Remove four nuts on top of shock tower. Remove strut Compress spring, remove nut from the end and remove from strut Install new spring, compress and put nut back in top of strut Reverse process Sport looks mean.....not slammed.....coupled with 1" spacers front and rear really looks sharp.