Search results

Thank you. I have replaced the break switch 3x's, but you are right about the locks. They lock sometimes and sometimes they don't.

Thank You! Thank you!

BCM Location? Thank you both for the replies. Where would I find the BCM and can that be tested? I am unemployed and the vehicle is due for inspection next month, so I am hoping for a reletively inexpensive repair, at least temporarily... If I can get it to pass inspection, I will have a...

97 EX - V8 AWD Eddie Bauer My break lights, door locks, and gear shift lever all seem to be connected. After break lights stopped working I replaced the break pedal switch 2x's. I have 4 issues: The message center tells me to check the break lights whenever I start the vehicle and apply...

The gas station I use has a fuel system cleaner that pumps into your tank while pumping the gas, if you buy it. I started buying it when the Explorer started acting up, but it didn't seem to help. I guess after 4 tank-fulls, it finally loosened up the carbon deposits enough to work. I do...

FIXED!!!!!!!!!!!!! This past Monday I drove to the auto parts store to see how much new injectors cost. The owner of the store suggested i pour "Sea Foam - fuel system cleaner" into the tank. The Explorer hadn't mis-fired the whole drive in, so I bought a can and poured it in the tank...

I am getting a spark on all cylinders. I am now betting it is the injector, which looks like a pain to get to. I will try swapping out the injectors next.

OK, I just replaced the Cam Position Sensor and still P0308 and mis-firing... Any other ideas?

I swapped out the coils and still have P0308 code.

I replaces the crankshaft position sensor, is there a cam position sensor also?

I replaced the coils with new ones and still had same issue.

How would I check the injectors?

I just replaced the crankshaft position sensor. No luck. I rechecked the plugs & wires, even swapped out cylinder 8 plug with yet another new one. Still getting code P0308.

I've been told that if there is coolant in the oil or oil in the coolant, then there is a leak in the headgasket. But, I don't have either problem.

It was gasoline on the sparkplug.

My Explorer started running rough w/CEL on. Code received P0308. I replaced fuel filter, air filter, spark plugs, wires, coil pack. When removing Cyl 8 plug, there was moisture on internal end of plug. Plugs looked fine, but replaced any way. Vehicle idles fine when in park. Runs fine...