Search results

add some sway bar disconnects on the back and the left tire will set on the ground

Update: checked the booster at the tree no change however when I disconnected the brake booster line and the cruise control hose at the tree, if I leave these hoses open it drops to 1200 rpms. Ive cleaned the tb as well as the iac, the maf is brandnew if I disconnet the tps it revs higher than...

Dont knowhow to reset the ecm. As far as the tb I cleaned it today. The truck is now revvig around 2000 rpm when I downshift and the maf disconnected. Also if it helps the truck is surging slightly. As far as basics go I disconected the battery, ive cleaned the tb, ran injector cleaner through...

I have a 92 mazda navajo 5spd the problem I am having is after I replaced the starter now the truck is revving nome stop around 3000 rpms I disconnected the mass air flow sensor and it,stopped reving but runs erradically I replaced the mass air flow sensor and no change I cleanded the iac no...

Update: thought about breaking the pulley Didn't have to. I had a smart moment and grabbed my Tie rod and ball joint tool, the ball joint tool fit behind the pulley 2 whacks of a hammer and the pulley shoot off.

Sorry I was flustered and in a hurry with my original post The pump is still in the vehicle hence the r & r Or remove and replace. Sorry I forget that not everyone knows my shorthand This pump has to have the oillt removed to get to the pumps mounting bolts. They make a tool to remove...

Yes off the front of the pump

Sorry for the misspelled words. I have a 92 Mazda Navajo 4.0 ohv. My power steering pump locked up & I'm trying to r & r it. The problem I'm having is the pump will pull with the removeal tool about a half an inch then the tool breaks I'm on my 3rd tool I've used PB blaster and it still...

Got the problem resolved I replaced the none existent bushings on the shift ball not hard to do cost to fix $10 and 1 hour including drive time

I have a 92 Mazda Navajo with the M5OD synchromesh 5 speed. The problem I'm having is when I put it in 3rd I have to put the shifter almost into the 5th gear area and then once its in gear it looks as tho its in neutral on top of this when I try to shift to 5th I'm having to play with the...

Ok im adding a mans perspective on the womans side. You don't have to follow the list to the letter just learn what your lady wants and then Fufill it. First tell her you care A lot. Help around the house not just mowin the grass or takin out the trash. And every now and then give her a massage...

There isn't supposed to be a gap on the radius arm bushings also death wobble is where the bushings have gone bad and allow the wheel to move in the pocket so to speak and it gets worse the faster you drive

There are to many issues that can be the problem starting with front wheel alignment make sure its right if the vibration is in the steering wheel if its in the seat area its coming from the rear of the vehicle check all four tires for balance and rim damage also a warped rim will balance out...

My baby is a 1992 Mazda Navajo 4.0 5spd tranny she is only a 2x4 for the time being extras are CB radio linear 1000 watts pa speaker behind the grille set of 100 watt lights on the front set of 55 watt lights on the rear just added a roof rack doing soa within the next few months. Gulfport, Ms...

Had the same problem a few months back checked tested retested finally just drove the truck wound up having to buy a 2nd new battery and alternator the problem was the voltage regulator and I recomend buying a new not remaned alternator I went cheap and replaced it with the new one 2 weeks later

My bad guys I failed to mention that the valve chatter is also after a rebuild I was working as a mechanic and some old schools as they liked to be called recommended it when I got the truck. I replaced the rings and went up from there new heads and all. The motor only has to make it one more...

Ok I have a 92 Mazda Navajo 5 spd 4.0 V6 it has 195,000 on it 2 months ago I got an oil change and switched to full synthetic 10w40 due to my valves rattling with the old 30 weight in it I still have valve chatter on start ups and hot weather passing speeds Im wondering if I can switch to a...

I have a 92 Navajo and was looking to do something similar and found you would have to buy new radius arms due to the old ones not being quite long enough I was trying for 4" thou I wound up just doing the SOA and buying new coil springs for the front I don't like the ride very much as mine is a...

Ok first off sorry for the miss spelled word I use my cell for internet access and the auto spell does what it wants. 2nd Ive had guys with federals compare them to iroqs they say they bite hard. And as far a tire size I can go 32s bone stock due to the mazdas coming stock with 3" shackles...

Ok so I noticed a set of Federals at my local redneck tire shop today and fell unlove with them. First my tire guy tells Me they are tuff and have killed several axles I have a 2x4 Mazda Navajo with 8.8 rearend 327 gears and a planitary locker does anyone know if I need to upgrade anything...

Thanks for all the help I had to add a 4 prong relay and take connect the lights to a toggle switch but everything works great and the lights seem brighter

Thanks the thread was very informative im going to get 2 relays one for each light and connection my only problem is going to be instalation right now my wires are spliced directly into my highbeam wires and Id like to be able to keep them hooked up so they will come on and go off with my...

I have added 2 55 watt rectangular hella lights to the front of my 92 Mazda Navajo they are spliced into my highbeam wireing so they will come on when I turn on my highbeams the first trip they worked fine now when I turn them on after 5 mins my lights are flashing on and off first the hellas...

I am planing on installing a divorced transfer case in my 2wd Navajo and im curious as to wheter or not I may be able to just get a bw 15/35 transfer case and just install a plate on it to make it work any sugesstions would be appreciated

my CB setup Ok guys I can't post Pics of mine but this is what I have to start a Wilson 5000 10/11 meter antenna with aftermarket magnet mount and 1 ft extension for swr reasons the antenna is on the roof right behind my sunroof next is my Galaxy DX 959 with 80 watt finals modulator kit and...