Search results

I've discovered that pin 8 (memory) of the grey connector (8 pin connector) in my Dash has 0V on it. This is the pin that is supposed to be at battery voltage and is un-switched, so regardless of ignition switch it is supposed to be always on. This is causing me problems hooking up a new...

I have the following trouble code come up on my 96 Explorer sport (146K miles):- P0401 - Exhaust Gas Recirculation Flow Insufficient detected P0402 - Exhaust Gas Recirculation Flow Excessive detected P0420 - Catalyst System Efficiency Below Threshold (Bank 1) I recently took my vehicle...

1996 Ford Explorer Sport 4WD control-trac. I appear to be experiencing slippage in the transfer case area. The Haynes manual refers to an 'electrical clutch (that) activate(s) the front driveshaft depending upon road condition'. I think that this 'clutch' may be slipping... I think that I...

1996 Ford Explorer 4x4 sport. Attempting to replace the U-joints in the double cardon at the front of the driveshaft. (The rear U-joint I have succesfully replaced). Ford will only sell me one of the U-joints, claiming that the other is non-serviceable. They don't tell me which one of the...

Hi, I wondered if it was OK to drive in 4WD on dry pavement with no driveshaft in place. Thus, the front wheels are only being driven, as the rear wheels are not connected to the drivetrain. Would this cause any damage to the vehicle? (The reason, I'm asking is because I'm half way through...