Signal Wires

Jemplyr77 · 01-03-2012, 01:43 PM

Anybody know if the wires for the front turn signals is located in the wire bundle behind the drivers side kickplate? If so do you know what color they are? I know the rear ones are but I believe they are used for the brake lights as well. 2010 STA.

Thanks in advance.

**ncranchero** · 01-06-2012, 01:36 PM

They run through the firewall. The left is BU/GN the right is YE/VT

Jemplyr77 · 01-07-2012, 11:40 AM

Thanks. I tried to locate them in there but it is just too tight and cramped to get in there. I had some muth signal mirrors installed and they wired them to the taillights so they work as brake lights as well. I was just wanting them to work as signals so I was going to try and rewire but I just can't get in there.

01-03-2012, 01:43 PM	#1
Jemplyr77 Wannabe Elite Explorer Mustang, OK Join Date: Jul 2010 Posts: 7 Vehicle Specs (Original Poster)	Signal Wires Anybody know if the wires for the front turn signals is located in the wire bundle behind the drivers side kickplate? If so do you know what color they are? I know the rear ones are but I believe they are used for the brake lights as well. 2010 STA. Thanks in advance.

01-06-2012, 01:36 PM	#2
ncranchero Sport Trac Moderator Denver,NC Truckin' on Pat & Charlie Join Date: Aug 2004 Posts: 3,562 Vehicle Specs	They run through the firewall. The left is BU/GN the right is YE/VT __________________ Steve, 2010 Transit CONNECT 145K miles, 2002 Sport Trac 4x4 SOLD 2000 Taurus SES 3.0L 24 Valve DOHC Duratec 87K miles 1994 F150 4x4 4.9L/5-speed 160K miles, 1995 Ranger 2.3L/5-sp/3.73 75K miles "Plain Jane" How to post photos

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
New HU Install Alternative Method - Front Speaker Bypass	zombie_fied	Stock 1995 - 2001 Explorers	0	07-09-2010 01:47 AM
Burned out front signal bulb - not burned out	gsmaclean	Stock 2002 - 2005 Explorers	5	07-01-2009 04:56 PM
$%&@!# Plug Wires!	MountaineerGreen	Under the Hood	49	09-23-2008 04:14 PM
Which spark plug wires to purchase	aldive	Under the Hood	22	01-07-2007 12:33 PM
Could i use the same power and signal wires from the factory amp??	Mr. Limited	Explorer Audio & Navigation	6	08-06-2000 04:56 PM

01-07-2012, 11:40 AM	#3
Jemplyr77 Wannabe Elite Explorer Mustang, OK Join Date: Jul 2010 Posts: 7 Vehicle Specs (Original Poster)	Thanks. I tried to locate them in there but it is just too tight and cramped to get in there. I had some muth signal mirrors installed and they wired them to the taillights so they work as brake lights as well. I was just wanting them to work as signals so I was going to try and rewire but I just can't get in there.