- Joined
- February 15, 2010
- Messages
- 7,837
- Reaction score
- 24
- City, State
- Charlestown, RI
- Year, Model & Trim Level
- 2014 Escape SE
I replaced my Multifunction recently and searched the forum for instructions but didn't find any. Maybe I didn't look in the right place. Hey, I'm not that bright to begin with. I thought I'd do a write up on this procedure.
Be sure to check out my other write-ups:
How To: Replace Blend Door Actuator in 3rd Gen Ex
How To: Remove/Replace 3rd Gen Door Panel
How To: Install Signal Mirrors On 3rd Gen Ex
How To: Restore Faded, Yellowing Headlights
How To: Paint Rear Pillar Trim
How To: Replace 3rd Gen Ambient Air Temperature Sensor
How To: Test a Relay
How To: Remove/Replace 3rd Gen Center Console
It's not that difficult. If I can do it, anyone can. This is my first write up so go easy on me. Here we go:
Installation is reverse of removal.
I took my time with this as I was enjoying some adult beverages. I guess it could be done in about a half hour. Hope this helps out. The forum has been good to me and I hope this gives a little back.
Thanks, Rondo
Be sure to check out my other write-ups:
How To: Replace Blend Door Actuator in 3rd Gen Ex
How To: Remove/Replace 3rd Gen Door Panel
How To: Install Signal Mirrors On 3rd Gen Ex
How To: Restore Faded, Yellowing Headlights
How To: Paint Rear Pillar Trim
How To: Replace 3rd Gen Ambient Air Temperature Sensor
How To: Test a Relay
How To: Remove/Replace 3rd Gen Center Console
It's not that difficult. If I can do it, anyone can. This is my first write up so go easy on me. Here we go:
Installation is reverse of removal.
I took my time with this as I was enjoying some adult beverages. I guess it could be done in about a half hour. Hope this helps out. The forum has been good to me and I hope this gives a little back.
Thanks, Rondo