jamilayers22
New Member
- Joined
- November 13, 2014
- Messages
- 5
- Reaction score
- 0
- Year, Model & Trim Level
- 94 ranger stx
Ok, so I replaced the shift motor on my transfer case (94 ranger stx manual hubs push button 4x4). That was simple. and 4 wheel drive worked. But only for a while. I dont know what happened in between it working and not working however I am getting different symptoms this time.
1. buttons dont light up when I push them
2. module makes no sound at all when I push button
3. trouble shoot module, everything seems great??? lights work when I ground the specific wires.
4. I have voltage to the button as well, its not the 12v that it says its supposed to have but its the same as it was when I knew it worked. (took the blue/white wire and backprobed then connected to ohm meter, then other probe to ground)
its like the signal is not being sent from the switch? I checked all of the fuses, cleaned some grounds on the battery, checked all the wiring, I am at a loss help.
1. buttons dont light up when I push them
2. module makes no sound at all when I push button
3. trouble shoot module, everything seems great??? lights work when I ground the specific wires.
4. I have voltage to the button as well, its not the 12v that it says its supposed to have but its the same as it was when I knew it worked. (took the blue/white wire and backprobed then connected to ohm meter, then other probe to ground)
its like the signal is not being sent from the switch? I checked all of the fuses, cleaned some grounds on the battery, checked all the wiring, I am at a loss help.