My 02 Explorer with rear A/C has this infamous clicking noise in the back caused by the failed heater blend door actuator. I really don't need hot air in the back. Is there any easy way to disconnect the wiring to it?
I pulled out the cover of the door lock switch above the rear blend door area, and saw several harnesses. Here is a picture I found on the internet, in which the rear panel has been removed and the whole black box covering the rear blend door actuator is completely exposed. You can see there are a few harnesses and wirings, etc.
Can some one tell me which harness/wiring is for the rear heater blend door actuator? I do not want to replace the actuator. I just want to disconnect it and it will never make the noise. As I said I really do not need hot air in the back.
I pulled out the cover of the door lock switch above the rear blend door area, and saw several harnesses. Here is a picture I found on the internet, in which the rear panel has been removed and the whole black box covering the rear blend door actuator is completely exposed. You can see there are a few harnesses and wirings, etc.
Can some one tell me which harness/wiring is for the rear heater blend door actuator? I do not want to replace the actuator. I just want to disconnect it and it will never make the noise. As I said I really do not need hot air in the back.