cut | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

cut

  1. Eric Z

    Explorer PIU Overhead Cut Out Question

    I have a 2015 and am looking for ideas as to what to do with a hole left in the overhead. I assume it was some sort of radio or maybe light control panel, but what was in there and what are people doing when they civilize theirs? Was thinking of overhead lights, but can not seem to find any...
  2. 2

    Cutting into dash?

    Has anyone here cut into the dash? I'm trying to add USB ports using the existing spot for the EATC sensor, but the dash almost looks like it has metal material on the back. Any advice would be appreciated, thanks. Update: It took an xacto knife and a lot of muscle, but I managed to expand the...
  3. The foam insulation has to be cut.

    The foam insulation has to be cut.

  4. Use the template to cut the light.

    Use the template to cut the light.

  5. A template is made from the cut taillight.

    A template is made from the cut taillight.

  6. Taillights with & without a cut out.

    Taillights with & without a cut out.

    The light on the left is for a non rear wiper equipped Aerostar. The light on the right is for a rear wiper equipped Aerostar.
  7. Camo BroncoII

    Camo BroncoII

    Camo Bronco II spotted at Park Meadows mall in Littleton, Colorado
  8. Nice clean cut.

    Nice clean cut.

  9. Old capillary filter cut open with crystals still inside.

    Old capillary filter cut open with crystals still inside.

  10. Old capillary filter cut open.

    Old capillary filter cut open.

  11. The rear shafts need to be cut to the width of the door.

    The rear shafts need to be cut to the width of the door.

  12. The top is cut off.

    The top is cut off.

  13. A larger view of the gasket being cut.

    A larger view of the gasket being cut.

  14. Cut away view of an oil filter

    Cut away view of an oil filter

  15. Fuel Pump inertia switch

    Fuel Pump inertia switch

  16. New exhaust tip

    New exhaust tip

    My new 2.5" slash cut tip to replace my 3" rolled tip
Back
Top