After replacing the BCM with one that is well matched to mine, I'm still experiencing the same problems. I am not getting power to the ignition through the stock wiring harness. There could be other things that aren't getting power, but I'm not sure yet of everything. The ignition doesn't recognize that the key is in position. If I add power directly to the ignition by unplugging my aftermarket remote start module and jumping power from battery input to ignition/accessory/starter output, I get accessory power, but am still unable to start the car. I used to be able to remote start the vehicle after initially damaging the stock BCM, but after replacing the BCM, I'm no longer able to remote start the car. I only get continuous power to 3 fuses in the cabin BCM. All fuses in the engine bay BCM and cabin have been checked. The relays have been swapped out in the engine bay BCM, with no discernible difference. I'm not sure if this is normal or not, I can't seem to be able to find a list of what fuses should be continuous, ignition or accessory. Anyone have any ideas?