skycitadel
Member
- Joined
- April 4, 2009
- Messages
- 17
- Reaction score
- 0
- City, State
- okc, ok
- Year, Model & Trim Level
- 1996 4.0
To summarize so far
Problem: OD and R slip so much i can barely move. once OD button is off i have forward movement up to 3rd. My OD light does not blink and i have not been able to get a code.
Troubleshooting so far:
Dropped transmission pan...no metal parts and clean fluid.
I replaced my EPC solenoid.
Other solenoids looked ok.
I checked the ohms on the solenoids
The solenoid bracket appears ok.
changed gaskets on valve body
changed internal wire harness
changed reverse servo gasket and o rings
Reverse Servo appeared ok.
Reverse Servo Bore was not scratched.
Reverse Servo has spring tension
toqued band adjustments
new mobil 1 synthetic fluid
new pan gasket and filter
pressure tested
I have a 4r55e
Hi,
I have a 1995 Explorer 4.0 4x4. I have no OD and almost no reverse. I can rev it up real high in reverse and get a little movement. Can still drive with OD off. Dropped the transmission pan and found no metal parts and clean fluid. I replaced my EPC solenoid. No change in condition. I have one code currently 214 which i think is my cam position sensor. My OD light does not blink.
Does anyone have any ideas for troubleshooting this? I have yet to read any posts with same symptoms. Most are either no OD or no Reverse not both.
Thanks for any input,
Michael
Problem: OD and R slip so much i can barely move. once OD button is off i have forward movement up to 3rd. My OD light does not blink and i have not been able to get a code.
Troubleshooting so far:
Dropped transmission pan...no metal parts and clean fluid.
I replaced my EPC solenoid.
Other solenoids looked ok.
I checked the ohms on the solenoids
The solenoid bracket appears ok.
changed gaskets on valve body
changed internal wire harness
changed reverse servo gasket and o rings
Reverse Servo appeared ok.
Reverse Servo Bore was not scratched.
Reverse Servo has spring tension
toqued band adjustments
new mobil 1 synthetic fluid
new pan gasket and filter
pressure tested
I have a 4r55e
Hi,
I have a 1995 Explorer 4.0 4x4. I have no OD and almost no reverse. I can rev it up real high in reverse and get a little movement. Can still drive with OD off. Dropped the transmission pan and found no metal parts and clean fluid. I replaced my EPC solenoid. No change in condition. I have one code currently 214 which i think is my cam position sensor. My OD light does not blink.
Does anyone have any ideas for troubleshooting this? I have yet to read any posts with same symptoms. Most are either no OD or no Reverse not both.
Thanks for any input,
Michael