PStansberry78
Active Member
- Joined
- April 29, 2014
- Messages
- 96
- Reaction score
- 0
- City, State
- Edmond, OK
- Year, Model & Trim Level
- 1993 Explorer XL
So... I assumed that replacing the O2 sensors in my 93' would be a reasonably simple project. The sensors are exposed and easy to get to on the bottom of the truck, and appear to simply screw in.
I haven't taken the old ones out yet, though, because when I went to disconnect the old one before removing it, I find that the harness plugs in way up behind the engine in the engine compartment.
What's the trick to getting to this? I can't seem to reach where the driver side O2 sensor plugs in, and I can't even see where the passenger side one does...
What say ye'?
I haven't taken the old ones out yet, though, because when I went to disconnect the old one before removing it, I find that the harness plugs in way up behind the engine in the engine compartment.
What's the trick to getting to this? I can't seem to reach where the driver side O2 sensor plugs in, and I can't even see where the passenger side one does...
What say ye'?