gh0st
New Member
- Joined
- October 18, 2019
- Messages
- 4
- Reaction score
- 0
- Year, Model & Trim Level
- 2015 Explorer XLT 3.5 NA
Hello everyone,
I wasn't sure if this fell under the 2015 sync 2 forum or this one, so here we are lol.
So I just swapped my 2015 Explorer MFT Sync 2 to Sync 3 GEN4, Ver 3.3. I have figured out how to enable all of my features in the APIM.
The issue is that my screen stays on when I turn off and lock the vehicle. The screen does its power off video, but at night I can see that the backlight is still on.
I have tried using the AsBuilt data from a 2017 and I will soon try using a 2020 (from my research it comes with the new GEN4 sync 3 2019 model). It has the one usb port on the rear.
I have been bashing my head in trying all sorts of values to try and figure it out. I even tried the default APIM AsBuilt (from a Ford Everest), and it exhibits the same symptoms.
Now one issue I do have is that I am awaiting a new USB hub, as the one I bought on eBay was lacking the darn microusb connector in the hub. WTF??
Maybe it is looking for this as the USB is not connected?
All my internet searching has not turned up any good leads.
I would appreciate any help or suggestions. I'm weary that this is going to kill my car battery.
I wasn't sure if this fell under the 2015 sync 2 forum or this one, so here we are lol.
So I just swapped my 2015 Explorer MFT Sync 2 to Sync 3 GEN4, Ver 3.3. I have figured out how to enable all of my features in the APIM.
The issue is that my screen stays on when I turn off and lock the vehicle. The screen does its power off video, but at night I can see that the backlight is still on.
I have tried using the AsBuilt data from a 2017 and I will soon try using a 2020 (from my research it comes with the new GEN4 sync 3 2019 model). It has the one usb port on the rear.
I have been bashing my head in trying all sorts of values to try and figure it out. I even tried the default APIM AsBuilt (from a Ford Everest), and it exhibits the same symptoms.
Now one issue I do have is that I am awaiting a new USB hub, as the one I bought on eBay was lacking the darn microusb connector in the hub. WTF??
Maybe it is looking for this as the USB is not connected?
All my internet searching has not turned up any good leads.
I would appreciate any help or suggestions. I'm weary that this is going to kill my car battery.