Querys
Well-Known Member
- Joined
- August 22, 2018
- Messages
- 177
- Reaction score
- 14
- Location
- Germany
- City, State
- Cologne
- Year, Model & Trim Level
- 2013, Explorer Limited
Hello,
Does anyone know if it is possible to deactivate the brake lights for the Trailer wiring by programming the BCM with ForScan?
Due to German legal requirements we have a different setup for the trailer connector. This makes is mandatory to seperate the turn signal from the brake signal.
1 turn left
2 Rear Fog Light
3 Ground
4 turn right
5 positioning light right
6 brake light
7 positioning light left
8 reverse light
9 battery +
10 charge wire
11 fre
12 free
13 ground Pin 9-12
I want to avoid cutting wires, but if nothing helps, I will disconnect the wires from BCM to the relay and connect them instead to the rear vehicles turn signals.
Does anyone know if it is possible to deactivate the brake lights for the Trailer wiring by programming the BCM with ForScan?
Due to German legal requirements we have a different setup for the trailer connector. This makes is mandatory to seperate the turn signal from the brake signal.
1 turn left
2 Rear Fog Light
3 Ground
4 turn right
5 positioning light right
6 brake light
7 positioning light left
8 reverse light
9 battery +
10 charge wire
11 fre
12 free
13 ground Pin 9-12
I want to avoid cutting wires, but if nothing helps, I will disconnect the wires from BCM to the relay and connect them instead to the rear vehicles turn signals.