These are the codes that I pulled from the modules, the ABS one is a wheel speed sensor when I hit some abruptly, like a rough rail road crossing at speed (has happened twice ever). I tested all of the modules with Forscan and none of them returned any issues except the BCM for my headlamps which I have retrofitted to HID. The HID's have their own separate circuits and the stock halogen signal drives the relay which isn't enough current for the BCM to detect them, hence I get a open circuit fault for both lights.
Noted: the more load I can put on with interior accessories the more I can get this to happen. The Sync Module also drops out, I can tell by the bluetooth icon disappearing for a bit. The movement of my power seat and playing with the washer / wipers will also trigger it. I have determined that all of these devices link back to the smart power junction. What I am unsure of is if this is what Ford considers the BCM? Perhaps someone can give me some insight on this.
Codes from the modules:
===RTM DTC None===
Successful DTC reading, no error codes found
Module: Radio Transceiver Module
===END RTM DTC None===
===HVAC DTC U3003:17-08===
Code: U3003 - Battery Voltage
Additional Fault Symptom:
- Circuit Voltage Above Threshold
Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Heating Ventilation Air Conditioning
===END HVAC DTC U3003:17-08===
===GPSM DTC None===
Successful DTC reading, no error codes found
Module: Global Positioning System Module
===END GPSM DTC None===
===PCM DTC None===
Successful DTC reading, no error codes found
Module: Powertrain Control Module
===END PCM DTC None===
===OBDII DTC None===
Successful DTC reading, no error codes found
Module: On Board Diagnostic II
===END OBDII DTC None===
===APIM DTC B1D79:11-28===
Code: B1D79 - Microphone Input
Additional Fault Symptom:
- Circuit Short To Ground
Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Accessory Protocol Interface Module
===END APIM DTC B1D79:11-28===
===APIM DTC U3003:17-28===
Code: U3003 - Battery Voltage
Additional Fault Symptom:
- Circuit Voltage Above Threshold
Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Accessory Protocol Interface Module
===END APIM DTC U3003:17-28===
===FCIM DTC U3003:17-08===
Code: U3003 - Battery Voltage
Additional Fault Symptom:
- Circuit Voltage Above Threshold
Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Front Controls Interface Module
===END FCIM DTC U3003:17-08===
===FCDIM DTC None===
Successful DTC reading, no error codes found
Module: Front Control/Display Interface Module
===END FCDIM DTC None===
===FLM DTC None===
Successful DTC reading, no error codes found
Module: Front Lighting Control Module
===END FLM DTC None===
===ATCM DTC None===
Successful DTC reading, no error codes found
Module: All Terrain Control Module
===END ATCM DTC None===
===OCS DTC None===
Successful DTC reading, no error codes found
Module: Occupant Classification System Module
===END OCS DTC None===
===ABS DTC C1137:64-60===
Code: C1137 - Reverse gear switch
Additional Fault Symptom:
- Signal Plausibility Failure
Status:
- Malfunction Indicator Lamp is Off for this DTC
- Test not complete
Module: Antilock braking system
Freeze Frame :
-GLOBTIM: 48086773 sec - Global real time
-POWER_MODE: Running - Power Mode Status
-ABS: Inactive - ABS
-AYC: Inactive - AYC
-BTCS: Inactive - BTCS -201D
-HDC: Inactive - HDC
-RSC: Inactive - RSC
-BTC: Inactive - BTC
-VAC_BST_ST: Inactive - Active Vacuum Booster State
-BST_REL_SW: Inactive - Booster Release Switch State
-HYD_PMP_ST: Inactive - Hydraulic Pump State
-VPWR_ABS: 14.50 Volt - Module supply voltage
-VSS: 11.0 km/h - Vehicle Speed
===END ABS DTC C1137:64-60===
===ABS DTC U3003:16-60===
Code: U3003 - Battery Voltage
Additional Fault Symptom:
- Circuit Voltage Below Threshold
Status:
- Malfunction Indicator Lamp is Off for this DTC
- Test not complete
Module: Antilock braking system
Freeze Frame :
-GLOBTIM: 110320326 sec - Global real time
-POWER_MODE: Running - Power Mode Status
-ABS: Inactive - ABS
-AYC: Inactive - AYC
-BTCS: Inactive - BTCS -201D
-HDC: Inactive - HDC
-RSC: Inactive - RSC
-BTC: Inactive - BTC
-VAC_BST_ST: Inactive - Active Vacuum Booster State
-BST_REL_SW: Inactive - Booster Release Switch State
-HYD_PMP_ST: Inactive - Hydraulic Pump State
-VPWR_ABS: 9.60 Volt - Module supply voltage
-VSS: 0.0 km/h - Vehicle Speed
===END ABS DTC U3003:16-60===
===RCM DTC None===
Successful DTC reading, no error codes found
Module: Restraint Control Module
===END RCM DTC None===
===PAM DTC None===
Successful DTC reading, no error codes found
Module: Parking Aid Module
===END PAM DTC None===
===PSCM DTC U3003:68-08===
Code: U3003 - Battery Voltage
Additional Fault Symptom:
- Event Information
Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Power Steering Control Module
Freeze Frame :
-SWRS: 0 rev/min - Steering Wheel Rotation Speed
-SW_ANGLE: -38.90 ° - Steering Wheel Angle
===END PSCM DTC U3003:68-08===
===PSCM DTC U0415:00-08===
Code: U0415 - Invalid Data Received from Anti-Lock Brake System (ABS) Control Module A
Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Power Steering Control Module
Freeze Frame :
-SWRS: 0 rev/min - Steering Wheel Rotation Speed
-SW_ANGLE: 4.00 ° - Steering Wheel Angle
===END PSCM DTC U0415:00-08===
===ACM DTC U3003:17-08===
Code: U3003 - Battery Voltage
Additional Fault Symptom:
- Circuit Voltage Above Threshold
Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Audio Control Module
===END ACM DTC U3003:17-08===
===BdyCM DTC U3003:17-08===
Code: U3003 - Battery Voltage
Additional Fault Symptom:
- Circuit Voltage Above Threshold
Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Body Control Module
===END BdyCM DTC U3003:17-08===
===SCCM DTC None===
Successful DTC reading, no error codes found
Module: Steering Column Control Module
===END SCCM DTC None===
===IPC DTC U0422:00-28===
Code: U0422 - Invalid Data Received From Body Control Module
Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Instrument Panel Control Module
===END IPC DTC U0422:00-28===