Front axle outer 'U' joint Size

[Tony H]

Two listed... a 1 1/16" bearing size and a 1 3/16" bearing size
(#436 and #371) .

Was there one size for Auto trani's and one for Manuals?

I was hoping to buy the part before sliding the axles. '91 Auto

 

[scas]

This may or may not help, but on the 94 auto hub, the part number is 15-2054-6 for the outer u-joints. I just replaced mine and that's what I needed. If not, sorry.

 

[Tony H]

Who's part number is that?

 

[scas]

It seems to work at a few places. I got them from ISP/napa

 

[scas]

U a p. Sorry trying to use an iPod for this. Damn broken computers

 

[Tremblor]

The difference between the 2 U joint part numbers you are referring to are that one U joint is for the dana 28 front end, and one is for the Dana 35 front end. Get the bigger of the 2 U joints. Some rangers with the 3.0L V6 had the dana 28 and came with slightly smaller U joints. Hope this helps.

 

[Tony H]

The difference between the 2 U joint part numbers you are referring to are that one U joint is for the dana 28 front end, and one is for the Dana 35 front end. Get the bigger of the 2 U joints. Some rangers with the 3.0L V6 had the dana 28 and came with slightly smaller U joints. Hope this helps.

NICE that's what I was looking for. I'm Surprised that the Auto Parts websites that I went on ( NAPA, AutoZone) didn't state " 28axle" "35axle"
Many times they will.

Ok 1 3/16th" it is