Last week, I replaced my KC Daylighters on my grille guard with a 21" 7200 lumen LED bar. The KC's had HID's in them but they had failed twice since I got them in 2011. So instead of replacing the HID's for a third time I just went ahead and replaced them altogether.
The first thing I had to do was measure where I was going to mount the bar as I had to drill new holes for the brackets. After doing that I drilled I believe two 5/16" holes. I started with my smallest drillbit and worked my way up until the bolts fit. Unfortunately I don't have any photos as I was pressed for time before work and I'm impatient and didn't want to wait until the next day.
After I had the holes drilled I mounted the light to the grille guard. That took about three minutes. To power the light, I used the existing wiring that I used for the KC's. For this, I used yellow for the supply to the relay and green for ground.
I ran both wires behind the headlight on the passenger side and out to where the air intake is. There was an existing ground located there so I just ran the ground to it.
The supply wire I ran into the front quarter panel around the shield for the air intake and back out to the relay.
Here is the finished product..
Lit up during the day..
Taken at night, LED bar only
LED bar, HID headlights, HID fog's
LED bar, HID headlights, HID fogs, halogen Hella 500's on the roof
The first thing I had to do was measure where I was going to mount the bar as I had to drill new holes for the brackets. After doing that I drilled I believe two 5/16" holes. I started with my smallest drillbit and worked my way up until the bolts fit. Unfortunately I don't have any photos as I was pressed for time before work and I'm impatient and didn't want to wait until the next day.
After I had the holes drilled I mounted the light to the grille guard. That took about three minutes. To power the light, I used the existing wiring that I used for the KC's. For this, I used yellow for the supply to the relay and green for ground.
I ran both wires behind the headlight on the passenger side and out to where the air intake is. There was an existing ground located there so I just ran the ground to it.
The supply wire I ran into the front quarter panel around the shield for the air intake and back out to the relay.
Here is the finished product..
Lit up during the day..
Taken at night, LED bar only
LED bar, HID headlights, HID fog's
LED bar, HID headlights, HID fogs, halogen Hella 500's on the roof