Radiator support

Well I started some body work and I am going to be replacing my radiator support. Anyone have any tips before I start?

 

[BrooklynBay]

Was the support damaged in an accident or is it bad due to old age? Where did you get a replacement part? It shouldn't be hard to replace.

 

[J08j06]

Was the support damaged in an accident or is it bad due to old age? Where did you get a replacement part? It shouldn't be hard to replace.

I have to buy the part still. The old one is rusted out. Its not too bad for 27 years. I wasnt sure if anyone has ever replaced one and had any tips.

 

[MONMIX]

I have replaced hundreds if not more core supports.
Maybe half a dozen on that gen Ford Explorer.

Do you have access to a MIG welder? Air compressor?

 

[karlos2]

Aside from a welder, you will need a drill and grinder also.

 

[DaaQ]

I highly recommend this https://www.amazon.com/Blair-11096-...pID=51IjAw-GfLL&preST=_SY300_QL70_&dpSrc=srch
I used the one kit to cut out two front clips on my donor and fixer truck. comes with 3 bits, two pilots.

 

[J08j06]

I highly recommend this https://www.amazon.com/Blair-11096-...pID=51IjAw-GfLL&preST=_SY300_QL70_&dpSrc=srch
I used the one kit to cut out two front clips on my donor and fixer truck. comes with 3 bits, two pilots.

I'm gonna have to look into purchasing that kit. I also have lots of body work to do other than the radiator support.