Mike Haas
New Member
- Joined
- February 9, 2020
- Messages
- 1
- Reaction score
- 0
- Location
- Danville
- City, State
- Danville, Pa
- Year, Model & Trim Level
- 1992 Ford Explorer
Hello,
Looking to see if anyone has a pin out for the wiring that would go to the ignition switch on the column. We are building an early Explorer to compete in the Line Mountain off road race here in Pa. Rules state we cannot use the factory key switch, so I am running power through two master disconnects, one at the back and one next to the driver seat. Want to make it as simple as possible, Basically want to turn on power with disconnect and hit the push button starter to ignite, but I can't seem to find what I need to tie into at the white plug at factory switch. Cage work is done and as well as the suspension work, just need to do the fuel system and wiring. Any help would be greatly appreciated.
Thanks,
Mike
Looking to see if anyone has a pin out for the wiring that would go to the ignition switch on the column. We are building an early Explorer to compete in the Line Mountain off road race here in Pa. Rules state we cannot use the factory key switch, so I am running power through two master disconnects, one at the back and one next to the driver seat. Want to make it as simple as possible, Basically want to turn on power with disconnect and hit the push button starter to ignite, but I can't seem to find what I need to tie into at the white plug at factory switch. Cage work is done and as well as the suspension work, just need to do the fuel system and wiring. Any help would be greatly appreciated.
Thanks,
Mike