Search results | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

Search results

  1. A

    Oxygen Sensor wiring harness mixup

    I'm trying to verify that I'm plugging the correct sensors into their respective plugs in the harness. I removed the old sensors, was distracted, and got back to working on replacing the new ones 3 hours later....couldn't remember which plug the left/right one goes in. I looked up the wiring...
  2. A

    How to: How To: Replacing Rear Axle Wheel Bearings

    Thanks for all the input! I picked up a set of the o-rings from Ford. The Ford P/N is: E9AZ4A332A, the description is "Axle Shaft Seal". The only place I could find them on Ford's site was under the "Buyer's Guide" section. $2.87 a piece.
  3. A

    How to: How To: Replacing Rear Axle Wheel Bearings

    Small o-rings by c-clip. Are they necessary? While reinstalling the c-clips onto the end of the axle I accidentally cut the small o-ring. Is the only purpose of this o-ring to keep a slight amount of pressure on the c-clip? Is it safe to run without it? Is it anything special? Or could I...
Back
Top