Search results

Yes:D and my report date got pushed a couple months later.

Any thoughts of running florence?

PM me if you wanna hit the trails!

chopped

Wow, that place is too far for me to drive the explorer. I will need to be towed for this one. How bout a florence run? :)

I would go but I need to install some new BLING!.

Cage Off-road radius arms

There's a couple of us here in Tucson. It's too hot for a day run right now but if you want a quick fun run PM me.

When's the next run up there? Don't forget about us southern AZ guys. ;)

Heimed radius arms? http://www.explorerforum.com/forums/showthread.php?t=100935 BTT!

After taking it out last weekend it got me motivated to start working on it again. I know, I can't make up my mind. :p Now I have to delete the other thread. :D Are you thinking of doing a cage for your X? We could do double bends and I'll supply the tube... food ;) . I don't mind...

DK Step Up (Cruiser)

I've seen the ones in your pic gallery but their not a very clear shots. What were the tubes made of again?

I need some ideas. I would like to chop the whole top off the explorer. :roll: JTX - where are the pics?

jrgaylor- no I'm not. Just swap the yoke end to 1330 while your at it, shouldn't cost much more and it will be a lot stronger than the ******* joint.

9" Here's my 9" rear. I got rid of the flange on the stock driveshaft which is used with the 8.8 output. Then I had the ds extended by 2" to compensate from taking out the flange and 2" more lift.

I won't make this one... again! :( The explorer's not ready. I have to work on the front end, change the bearings and other stuff. The cage (part of it) will be put in this weekend when I come back from Florida. Have fun out there!

Thank you, I try! :D

... Here's mine... going through another transformation.