Search results

the wheels just spin, maybe if you were to put 4 racing tires on at the track you might snap something due to too much traction after quite a while of abuse. This is assuming you floor it everywhere you go. If you were to modify your Explorer to the extent you need fuel upgrades and have added...

that's strange, if oil pressure is getting to the turbo so the shaft doesn't seize and the vacuum hose to the wastegate is not leaking so it isn't over revving it would be a bad turbo, but having so many failures is rare. You woudnt be able to open it to do an inspection incase they say you have...

is that a honda civic or accord interior:laugh:

I tried a few different ideas, even using an air compressor oil/water separator, didn't collect much attached in series to the factory rear separator on the valve cover, factory appears to be a good design as the oil puddling drains back into the valve cover. The front valve cover has a mini K&N...

I used an extended meant for the F150 on the older model Explorer, previous to the 2018s. As I mentioned it wasn't a night and day difference to me. It plugged right into the TPMS module once the back of the center console was removed. Maybe the 2018 might work on older models but I have no...

remove all the plugs and blow the plugs out and cylinders for a few minutes each with compressed air. Original issue might be bad injector, if a cylinder is flooded you can bend parts really quickly when cranking.

dead cell in battery etc, not charging

not sure if that's the final exhaust, but looks like it has two huge barrel sized mufflers with turndowns

cant complain it looks like a Range Rover anymore, front end looks like a Durangos.? or some dodge

there a few different versions for the 2013 body style Built for U.S.A models do not have Daytime Running Lights enabled from factory Canadian models all have DRLs turned on, if you have HID headlights the DRLs are the front amber parking lamps If you have a Canadian model with regular halogen...

it happens:dunno:, its not common to fail though

only "damage" to the inner would be if the boot wasn't clamped properly and might see a grease leak

always easier to remove the entire shaft if possible and work on it out of the vehicle. Trying to remove the outer joint in the vehicle might be tough if the outer joints snap ring wont budge. There are professional kits that allow you to cut the old boot off and stretch a special boot over the...

just wiggle it off, its looks like a heat shield for exhaust pipes

was it new or a refurbished axle? Only buy new axles in the future, used or repaired axles are hit and miss. mostly miss and will vibrate under acceleration because they didn't repair them properly.

does the steering wheel shake back and forth when braking at higher speeds all the time?

remove the panels back there and head to an a/c shop and have them drain the system and cap it off. I would disconnect the wiring first and see if any errors occur on your control panel. Make sure you cap any open holes to the outside if you want to keep exhaust gas from entering the vehicle. I...

you can plug the long bar shaped add on antenna with wire extension for the F150s and route it up a side pillar? Don't know if it was just me but I felt the remote was more consistent :dunno:. Best bet is to purchase the add on remote start module with the square shaped extended range antenna...

if not, maybe get a blank grille and buy the appropriate characters and stick them on? Would really stand out with a red back light but you're asking for a ticket then :eek:

no one knows till its scanned, if the computer gave the signal for the bags to deploy then something went wrong. If the air bag light always passed the self test when starting the vehicle they probably were not meant to deploy. On the other hand if there was a rollover they should have.

most sealers are self leveling for a few minutes after applying, after that they start to hold shape. I doubt the repairs would even be noticeable if the pictures were taken from a few feet away, especially being in the hinge area. Got lucky since sealer comes in 3 colors usually and paint...

unplug it, if it still goes off, plug it back in and don't tell them, a secret:laugh:

those modules are pretty straight forward as long as the correct one is installed. I think all years have a jumper pin if removed will activate the shock sensor portion of it (need to check install manual online). They hook up to the OBDII port under the dash and if unplugged should remove the...

my 2011 base had a hood switch harness but no switch, maybe in the later years they started counting pennies

Did they damage anything? Thief probably threw the change away because it made a lot of noise and sold the cupo_O