Search results

Congrats and nice work on the fender! I have one that looks identical to that! (Other than I just removed the running boards).

Normally a wire will burn out on the element itself. I repaired a seat out of a 2001 limited this way to install on my 93. You have to completely dismantle the seat to get at the element which is not too bad just time consuming. Then splice the wire or put in a new element (ebay i think has...

Almost sounds like too much toe :dunno:

the pup in the second pictures is hilarious :D !! Nice to see some progress on the ranger. Running Baja with that thing?

I am with Kirby N. everything looks good. Larger tires have more advantage on the steering components than the smaller so that would make the problem worse. What in the steering has changed since you built it?

How are the angles and length on the steering linkage (i.e. drag link, and straight line from frame bolt to axle mount on track bar)? Even with good components a little bit out can cause issues. And just to clarify do this start after going over a bump or does it start small and get...

Those are for the plastic manifold 4.0 OHV. 94+ I just did the same thing. I panicked slightly too. :)

:eek::(:( I hate to see this truck change hands. You must specify that whoever buys it has to keep it in the "RBV family" (i.e. explorerforum, rps, rangerstation). Good Luck with the sale! A truly top notch build!

Amazing Progress...can't wait to see it finished! Good luck with the Axle!

Factory Spec is .005 to .030" of end float with the center pin installed. I know that when I installed my ARB on my last truck they sent several thicknesses of C-clip just for this reason.

Alright so after a couple days work I got all the wiring run for the power and heat and while I was there I pull the carpet up to work on the shifter since it was terribly sloppy. I found once I had it out the boot was torn on the shifter allowing dirt to get in the tranny (not good.) Also the...

#1 seat in and warming!

Old shifter seal

Rubber Plugs and Old seal

Frozen and Rebuilt

What they don't say clearly is all the other parts you should have to operate the "rocky tool" They have special cutter, bolts, and extractors to use with that tool to make it work properly. That being said that is still a great solution to the problem. If you can reach put a punch to the...

That may be a little ambitious as I have a bathroom to work on as well....(construction takes to much thinking for me). But on the other hand the rear seats are installed. (Pictures tomorrow maybe) and I scored the rest of seats for front; a pair of heated seats from a 2000 Limited. They are...

Big Green Wire is the power seat feed

Tucked under the Fuse box

Another Junkyard find

Power distribution Location for Power Seats

I went too far

Welcome to the forum! I have never had either brand. sigma and hercules were the two we always ran on the farm. As for the noises going away, it is always nice the have new shoes on the rig. Hope things go well for you and you can complete the set.

you may try to do a price match through Ford or someone else to get tires... If all else fails, CL is your friend...