Search results | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

Search results

  1. C

    help!!!!!!!

    if you still need help... check the IAT (Intake Air Temp) and the ECT (Engine Coolant Temp) sensors. either of those would cause your problem. do you have any codes??
  2. C

    92 explorer no start

    pull the plugs and try turning the crank by hand. are there any codes?? when you try to crank it with the starter...how many amps does it take??
  3. C

    NEED PCM Wiring Diagram

    is it 2 or 4 wheel drive?? what is the 8th digit of the VIN code. will be E, X or P ?
  4. C

    97 UK Spec EX (Not PATS) Will Not Start

    with the replacement PCM installed was the autoeletrician able to communicate with the PCM and get codes?? if not, check fuse #11 Maxi 20Amp and Fuse #2 Maxi 30Amp and fuse #11 Mini 15Amp in Power Dist Box. check the fuses for power on both sides with the fuses plugged in and the key in RUN...
  5. C

    97 UK Spec EX (Not PATS) Will Not Start

    when you say..."Have had an autoelectrician look at it with his Snap-on diagnostics, but he had trouble getting any readings" do you mean he is unable to communicate with the PCM to get diagnostic codes?? what you call imobil are you refering to the RAP (Remote Anti-Theft Personality...
  6. C

    Tire Sensor Fault

    if it says 'low pressure' then you have a nail/screw in your tire. take the truck to discount tires or another tire store that repairs tires for free and get it fixed.
  7. C

    97 UK Spec EX (Not PATS) Will Not Start

    have you tried unlocking the driver's door with the key?? (don't use the remote) if that doesn't work then the RAP module may be bad. the Imobilizer dash light should come on if you lock the car with the remote after 30 seconds. NOTE: i'm using a tech cd for US vehicles. do you get...
  8. C

    02 sport trac won't crank

    you're correct, it's the PATS.
  9. C

    03 Sport Trac won't charge...

    it's fuse #6 in the second (which is the Central Junction box) fuse block. (the first fuse block is the Battery Junction box.) you should check the fuses with a meter. yes, those are them.
  10. C

    03 Sport Trac won't charge...

    have you checked fuse #2.6 7.5Amp in Central Junction box?? there are also 2 fusible links you need to check.
  11. C

    Programming Keyless Entry?

    what is the build date of your truck?? before or after 03/2002
  12. C

    OBD codes

    it's OBD I so you can you a code reader/scanner with the old adaptor or do it manually.
  13. C

    99 ford explorer overheating

    does it heat up while driving over 30mph or at idle?? have you had the cooling system flushed including the radiator?? is there anything blocking the fins on the condensor or radiator?? is the fan shoud intact?? is the fan clutch working properly??
  14. C

    Need some help finding this trim

    give this place a try...www.oefordparts.com...
  15. C

    Help! Truck spudders/backfires when cold!

    check what affects cold performance... IAT - Intake Air Temp sensor ECT - Engine Coolant Temp sensor
  16. C

    code 327 (check engine light)

    were the codes KOEO, KOER, or Memory?? did you clear the codes after replacing the DPFE?? did you connect the hoses in the correct places when replacing the DPFE??
  17. C

    Tranny Fluid Issues?

    the hard one. http://farm4.static.flickr.com/3394/3422439793_cb78c18449_b.jpg http://farm4.static.flickr.com/3378/3422439797_19e58c335b_b.jpg http://farm4.static.flickr.com/3400/3422439803_f5424d2bf1_b.jpg http://farm4.static.flickr.com/3587/3422439813_a8037cc735_b.jpg...
  18. C

    Tranny Fluid Issues?

    do you have the 5 or 6 speed tranny??
  19. C

    2006 explorer radiator

    if the heater isn't working then you should check the heater control valve and the vacuum connection to it. unfortunately, coolant only flows through the heater core when the heater is on. also, the radiator cap should keep the pressure low enough so the rad seams won't split. make sure...
  20. C

    CEL - Code 172

    you checked the middle plug but how about the other two?? it only takes one to cause a problem. you are correct, 172 indicates a problem with the right bank. as i said earlier, check for things that affect that bank, exhaust, plugs, plug wires, injectors, intake leaks (on that side), etc.
  21. C

    Emissions P0402 code? Any help is appreciated.

    402 - EGR Excess flow - when you replaced the EGR vavle, did you install the correct metering washer(looks just like a washer)?? are the vacuum hoses clear of any obstructions??
  22. C

    CEL - Code 172

    an exhaust leak at the manifold or where the pipe connects to the manifold could cause a problem but i've never seen a blown muffler cause an O2 problem. especially when there is a CAT between them.
  23. C

    Module Plate??

    i've never heard of a 'Module Plate'. there's a shift modulator, shift solenoids, could he be referring to the Valve body?? if so, that won't cause an external leak. you may want to have him explain what he ment by 'Module Plate'. also, where is the tranny leaking from??
  24. C

    CEL - Code 172

    Did you clear the code after doing the repairs?? also, with just 172 (lean bank 1) check for intake leaks, vacuum leaks, plugs, wires, etc. on that side. bank 1 is where the # 1 cyl is so passenger side.
  25. C

    ABS Control Module location?

    the control module is bolted to the hydraulic control unit. by 4 screws tightened to 18 INCH pounds. if you are replacing the module, it needs to be calibrated and configured to your vehicle.
Back
Top