4x4

So recently my explorer lost reverse, no neutral. Trans fluid is full and cable is adjusted properly. After reading similar posts I am pretty sure I have a problem with my z link in the trans. If someone who knows/experienced this procedure please help me out with the following; 1) Can I...

1992 Explorer XLT, just replaced the transfer case shift motor and 4x4 "works" but when driving it intermittently clunks hard when accelerating, braking and driving over 30km/h. It doesn't seem to be getting any worse just more annoying. I figure it could be a seized u-joint but i wonder what...

I drive a 1999 ford ranger xlt 4x4 it's lifted 3 inches and has 33s on it, when I'm driving at 60mph my rpms run right at 2100, so I looked at the door tag and it said I have 3.73s but I looked at my rear end and my tag is gone, so I believe it has been regeared before I bought it

so I have a 1992 explorer XLT that was sitting at 100k miles for 6 months before i bought it and since then ive put on maybe 2k more. anyways the front the diff is humming really bad at about 10km/h up. the 4x4 didnt work when i bought it (transfercase motor) after i replaced it, put it into 4hi...

I have a 93 explorer 4x4 stopped working, I can push the button and here clicking from 4x4 computer, so i figure next is to check and either rebuild or buy a new 4x4 shift motor. What I am wondering is if i remove it will the vehicle still be drivable if I need to go get parts or new one ? it...

I had been trying for about 45 minutes trying to figure out which transfer cases the Explorers used. I know the information is on here, but I guess I can't figure out the right combination of search phrases to use to get the t-case numbers and their years and their functions all used in the...

so my 1992 Explorer XLT wont shift into 4x4. ill push the 4hi button on the dash and nothing will happen, the light wont even come on. i was thinking it could be the shift motor but i'm wondering if you guys think it could be a more serious electrical issue.

I have my 2000 Sport for sale. I wish i did not have to let her go but I do. Here is a list of mods and specs........ Warrior Shackles Torsion lift RLC Bumper Rhino lined Tuff Stuff 9500K winch wired and wires controls RCI skid plate 17x8 Black Rock 997 rims Kenda Kleavers 32x10.5x17 matching...

Ok so I have this really weird vibration going on on my 97 4x4. It only happens once I stop accelerating and when I start slowing down (Using brakes or just coasting). It is not warped rotors because it happens when I'm not using any brakes at all as well as when I am braking. Another strange...

Okay, I am thinking about doing the BWM to my 2005 XLT just because I don't like not having the option to have 2wd. I have read all the forums and know exactly what I am to do... But today I pried up the passenger kick panel / floorboard plastic thing, expecting to find what everyone else has (2...

I am stuck in a field 20 minutes out side Cleveland need someone with a winch or someone with super swampers! been stuck for two days already please help!!!! 703-638-5814

Hi everyone. So I've been trying to get my 4x4 working. It's still not happening and I have a question and I'll say the things I've done. I have power and ground to the module. (about 11.5v) I did all the tests and the resistances seem to be good. The dash and button lights are...

I just bought a used '02 Explorer 4x4 and it's stuck in 4 High. I think the problem is the 4x4 module behind the glove box. If I try to shift in neutral, the 4 Low light just blinks. Before getting it fixed or the transfer case, if that's it, can I remove the front drive shaft so I don't cause...

Ok, so in doing my 4x4 conversion I have the factory d35 front end however I could not find a manual shift 1354 t-case ANYWHERE in my budget. I did however grab a 1350 manual shift. I had a spare front driveshaft from a BII that I had shortened 3 inches and balanced at a shop and it all bolts...

afternoon, i have failed to get to the bottom of my transfer case not engaging the front drive. my abs light is on and is throwing all sorts of codes about the wheel sensors and whatnot and it is just too cold to really work on it. so my question is that would it be possible to provide power...

I have a 2002 ford explorer xlt v8. My 4wd high light is on but its not shifting from high to low nor auto. I changed the 4wd control module and the transfer case but it still hasnt helped.

hi all, over the summer i did the BWM all has been good up until recently. with all of this snow i have been noticing that the transfer case is not engaging the front axle and i am constantly in 2WD. with this said i have a 2004 explorer 4.0 V6. my question is how does the PCM know when to...

I had a ranger and it had a switch to select 4X4. I had an AWD, and it was full time 4 wheel. My new one is a Gen 3, (2002), and I have not driven it yet. I want to know how the 4X4 works. I see the two switches, and I'm wondering if the 4X4 feature turns off, or just switches between...

My 02 Explorer is stuck in 4 lo. I have read a lot on here and am getting a replacement 4x4 control module, but is there anyway I can get my truck back in auto 4 wheel or 2 wheel drive while waiting for my part to arrive?

Hi everyone, Im new to the forum but will be a very active member now that Ive finally gotten my 2007 explorer xlt. Its the dark green V6 with tan leather interior and 3rd row seating. Ill post some pictures later, its completely stock right now. Okay so I have a question, well really 2...

Hello, This is my first post here and I am in need of some extreme help with my 4x4. I have an 1993 XLT with push button 4X4. When i bought it a few months back it worked. Now when I go to use it. Nothing works. No lights come on, no relays click. I have purchased a new control module which...

Hi, I'm Bryan. I have had many Fords and several Explorers including Sports and 4 doors. I currently have a 2010 Limited with a 4.6. It is AWD. Previously on my Eddie Bauer I had the options: auto, 4x4 hi, 4x4 low. I found I had better control in the Eddie Bauer in the snow. My limited...

Hey guys, my front axle won't engage but t-case will lock into low. So I get low 2wd. I have the bwm but have removed it and solder the wires back together Still don't work. All fuses are checked and good. all of the lights on the dash work. it's not the buttons and I don't think it's the...

ok, I replaced the rotors and brakes all the way around 2 months ago. Everything has been fine. Then the snow came and I engaged my 4X4 for the first time. After I disengaged, I got a horrible noise from the front passenger wheel. Got it in my garage and the hub assembly was shot. Replaced that...

I bought this 94 Explorer a few months back. I took the auto hubs off to clean them because they were not engaging since I put them back on it still doesn't work when I was cleaning the hubs up I noticed the female gear in the hub free spins, is this normal operation or is the hubs toast...