and | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

and

  1. The 1995 taillight is on the left. The 1996 taillight is on the right.

    The 1995 taillight is on the left. The 1996 taillight is on the right.

    This is a side by comparison between the socket holes on two Aerostar taillights.
  2. Aerostar doors, tracks, and bolts (description).

    Aerostar doors, tracks, and bolts (description).

  3. Aerostar doors, tracks, and bolts.

    Aerostar doors, tracks, and bolts.

  4. Insert the tool, and pull on the pipe to disconnect.

    Insert the tool, and pull on the pipe to disconnect.

  5. Accumulator, ignition module, and cycling switch.

    Accumulator, ignition module, and cycling switch.

  6. 1992 Aerostar turn, stop, and hazard light schematic.

    1992 Aerostar turn, stop, and hazard light schematic.

  7. Ratchet, M6-1.0 X 45 MM bolt, and 10 MM socket.

    Ratchet, M6-1.0 X 45 MM bolt, and 10 MM socket.

  8. Propane, broken bolt, bolt extractor, igniter, torx socket, and ratchet.

    Propane, broken bolt, bolt extractor, igniter, torx socket, and ratchet.

  9. The motor is installed, and the saw is ready to be closed up.

    The motor is installed, and the saw is ready to be closed up.

  10. Broken blade guard, and top handle comparison.

    Broken blade guard, and top handle comparison.

  11. 18 volt, and 14.4 volt trim saw comparison.

    18 volt, and 14.4 volt trim saw comparison.

  12. Skylight weatherstrip, mounting hardware, and handles.

    Skylight weatherstrip, mounting hardware, and handles.

  13. The top pin is in, and the bottom one is next.

    The top pin is in, and the bottom one is next.

  14. Tester, DMM, and a thermocouple.

    Tester, DMM, and a thermocouple.

  15. Hobby knife set, and a cutting board.

    Hobby knife set, and a cutting board.

  16. Repair socket and adapter.

    Repair socket and adapter.

  17. A4LD 4X4 with modulator, servo, and tag locations.

    A4LD 4X4 with modulator, servo, and tag locations.

  18. Converted utility tub with a drain valve, and a water filter.

    Converted utility tub with a drain valve, and a water filter.

  19. Front view of the trap, and flexible waste connector.

    Front view of the trap, and flexible waste connector.

  20. Faucet pop up assembly, sink bracket, and waste pipes.

    Faucet pop up assembly, sink bracket, and waste pipes.

  21. rack and pinion

    rack and pinion

    new rack and pinion for my truck.
  22. Complete pin and nail puller.

    Complete pin and nail puller.

    This slap hammer has a keyless chuck as a removable attachment. It could be used for pulling out nails from mouldings without leaving pry marks on the wood. Another use is for removing that subborn dowel pin on the bottom of a Ford transmission.
  23. Break out view of the pin and nail puller.

    Break out view of the pin and nail puller.

    This slap hammer has a keyless chuck as a removable attachment. It could be used for pulling out nails from mouldings without leaving pry marks on the wood. Another use is for removing that subborn dowel pin on the bottom of a Ford transmission.
  24. GM ECT and IAT temperature sensor resistance chart.

    GM ECT and IAT temperature sensor resistance chart.

    This chart is for diagnosing the GM engine coolant temperature sensor, and idle air temperature sensors.
  25. Ford fuel injection and electronic engine controls for EEC-IV.

    Ford fuel injection and electronic engine controls for EEC-IV.

Back
Top