door adjustment | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

door adjustment

  1. E

    97 Door doesn't shut flush with car body

    Recently I've noticed that my car door dosent sit flush when shut on my 97 Ford explorer. That is, the door, when shut, is a good 1/4 inch depressed from the rear door. The top and bottom lines up, and the sticker lines up and it latches, so it's not sagging. If you were to run your hand along...
  2. S

    Driver door rattle

    Hey guys so my explorer makes some noises, but this one is unbearable. My driver door closes and locks with no door ajar light. However, when I'm driving it rattles, and I can also push it closed all the way closed from the outside. It only seems to be not aligned right the top half of the door...
  3. C

    Back Hatch Adjustment

    Back Hatch Adjustment. I recently purchased a very nice 1992 Explorer Sport with only 76,000 miles. Its only problem is the back hatch is too high on the right side, and exhaust is leaking into the car. There is a very small dent in the door, just to the left of center, but I doubt it is...
  4. F

    2011 Passenger Door Allignment

    I know there is already a forum on this issue but I can not seem to find it. I have a 2011 ex limited and it seems as though the front passenger side door is BADLY misaligned. It is clear that the gap by the front fender is way off and where the door trim meets the center console does not...
  5. L

    4-FOUR!- problems w/1998 Ford Explorer NEWBIE here pls help

    I don't know if I'm even in the right forum, so please forgive me and correct me if I am- cuz I'll likely have more questions monthly! Just joined, and I have several problems in which I looked up in various forums but couldn't "relate" to the answers...so I'm going to try a new post here to...
  6. W

    Driver side door adjustment! HELP!

    The driver side door on my 1995 2 door explorer does not line up at the top. I tried to fix it and messed it up even more. I loosened the bolts on the top hinge and lifted up the door and tightened the bolts. Well then it was metal on metal where the hood and door meet! So I just put it back how...
Back
Top