egr valve

Hey guys, I have a 1997 f150 with a 4.6l v8, recently I took the throttle body and off to clean the EGR ports that were clogged from carbon buildup, unfortunately when I tried to take off the EGR both bolts holding it in place broke off, now I need to go to a machine shop to get the broken...

So I had a check engine light come on on my 2021 explorer xlt checked the ford pass app and scanned it with my tool, and both said EGR high temp. I looked under the hood and found a massive nest of grass on top of the engine, mind you this is a daily driver. where would I find the EGR valve to...

99 Eddie Bauer with 4.0 SOHC - 220xxx miles. For about a week now, it acts like its not getting fuel. It will start & run in the morning, but as soon as it gets hot, it dies. And won't start up again until it cools off. It also likes to die at idle, and sputter and backfire. When it does run, it...

Well... Seems I've made more work for myself... About six months ago I undertook two jobs that tested my skill level. Both with guidance from this blog, as well as hours spent under and above my '02 (June '01) Explorer Sport V6, 4.0L 4x4. I am currently dealing with multiple issues, and I'm...

So was working on my Explorer last weekend, wanting to change out the EGR Valve, as it is froze and rusted. Well I was trying to get the one nut off, and I ended up breaking the EGR Tube off clean at the nut down at the exhaust. So I ordered a new EGR tube, and am ready to put on the new EGR...

Hello, I'm new to this and am wondering if I can get advice on my problem. A few months ago my 1996 explorer XLT V8 broke down. My neighbor hooked it up to One of the handheld devices that gives you a diagnostic code. It showed a code for a bad EGR Valve, and a position sensor. I bought a new...

can not find delete post

Anyone have any tips to help me remove the DPFE sensor? I've got an '02 Explorer XLT. I've seen a couple vids of guys just pulling it up and off. But that's not working for me. It seems to be stuck on those tubes pretty tightly. Any suggestions for helping me remove it. I've tried...

Hey i have a 2005 Ford Exlporer 4.0. I've looked at a lot of posts and i know my EGR valve is bad so i have to replace it i already have the part but not sure how to install it. I don't know if i have to take the intake off cuz it doesnt look like much room around where the bolts are located. If...

Been here before and cleaned it two years ago, just did it again and its working fine. For the new guys here, if you have problems like the car starts and dies when you take foot of pedal, it starts and revs very high, it starts and surges- its prob your iac valve! Tools req- 10mm, 11mm...

My cat(s) are clogged. The shop called me and told me the cat on the left (drivers) side is blown out and emptied into the back cat, the passenger side one was not as bad. They are drilling out the bolts that support the tranny. They told me they have the new catalytic converter installed but...

Back Story: 171, 174 (lean bank 1 and 2) and 401 codes (low voltage EGR) Last weekend spent the weekend removing the upper intake manifold and took off the EGR. Din't look to bad but cleaned it up and replaced the gasket onthe EGR and upper intake manifold. Started it up... no change. Bad...

Hi Guys, I just get a brand new Ford Explorer 4.0 SOHC V6 2008 model. I made only 6400km( less 5000miles) and the yellow light is ON- message from my Ford dealer was " P0405". I looked on whole google about this message but are different opinions and answer- so I'm asking for some help...