is | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

is

  1. A multimeter is on my wrist.

    A multimeter is on my wrist.

  2. A multimeter is in the armband.

    A multimeter is in the armband.

  3. The 1995 taillight is on the left. The 1996 taillight is on the right.

    The 1995 taillight is on the left. The 1996 taillight is on the right.

    This is a side by comparison between the socket holes on two Aerostar taillights.
  4. The taillight on the left is the finished product.

    The taillight on the left is the finished product.

  5. A template is made from the cut taillight.

    A template is made from the cut taillight.

  6. Wire mesh is nailed down.

    Wire mesh is nailed down.

  7. Water is sprayed into the seams.

    Water is sprayed into the seams.

  8. The cutter is an attachment.

    The cutter is an attachment.

  9. Paver sealer is applied.

    Paver sealer is applied.

  10. Excess wire mesh is trimmed.

    Excess wire mesh is trimmed.

  11. A square is used to align the tiles.

    A square is used to align the tiles.

  12. Metal L bracket is installed.

    Metal L bracket is installed.

    The sliding door latch on an Aerostar was modified to keep the return spring in place.
  13. The blend door actuator is removed.

    The blend door actuator is removed.

  14. The blend door actuator is installed.

    The blend door actuator is installed.

  15. The wire from the light is secured in place.

    The wire from the light is secured in place.

  16. The light is installed.

    The light is installed.

  17. The face plate is installed.

    The face plate is installed.

  18. The hinge is removed.

    The hinge is removed.

  19. The Rockwell Jawstand is holding the door in place.

    The Rockwell Jawstand is holding the door in place.

  20. This is the lower mounting base of the alternator.

    This is the lower mounting base of the alternator.

  21. The tube is refilled after it's cleaned out.

    The tube is refilled after it's cleaned out.

  22. The bottom is replaced after it's refilled.

    The bottom is replaced after it's refilled.

  23. The base is connected to the power supply.

    The base is connected to the power supply.

    Power supply with the modified battery charging base.
  24. The pipe is removed.

    The pipe is removed.

  25. The accumulator is removed.

    The accumulator is removed.

Back
Top