loose

I have a 2006 Mercury Mountaineer 4.6 V8. It starts but stalls within a few seconds. I recently did a bunch of work to it (intake gaskets, valve cover gaskets, valve cover, vct sensor, crank sensor, etc) and now when I start it I hear a squealing/whining noise coming from the belt. I'm thinking...

Hi everyone, I just joined the forum. I've had a 98 Explorer XLT for about 12 years now (hey, it's paid off). Recently the headlight switch on my instrument panel had begun getting so loose that I could barely operate it. So I found a video on youtube from 1aauto.com and followed the directions...

Hey everyone. I recently got the code P0304 which indicates a misfire in cylinder 4, and I can feel the truck misfiring at start up. It goes away after about 30 seconds when the engine warms up. I had the plugs and wires replaced about 2 years ago and I just noticed that the boot on plug #4...

This has been a recurring issue for a while now. every so often the battery keeps sending power to everything after the engine is shut off as if the key were turned too far when powering down. I'd have to find the sweet spot that seems to get smaller and smaller each time I'd shut her down, and...

1995 Ford Explorer XLT 350K miles. I removed my serpentine belt to check the pulleys. The P/S pump pulley moved forward and backward about one sixteenth to 1/32 of an inch. The pulley is securely on the spline (shaft). I looked behind the pulley and moved it. It is the spline that is moving. Is...

Hello, I have a 98 explorer an recently my passenger side fog light came off of whatever holds it on, could some one please tell me how i can secure it again. Thank you.

Noticed a loud noise on the passenger side rear tire when backing out of the driveway. The noise sounded like a stick was being dragged and the truck was driving rough and choppy. Almost like it was riding on the brake off and on. Stopped the truck and looked under the truck and didn't see...

i been having this ever since i got my explorer... the handles the u use to open the door from the outside, theyre all loose and they dont seem to have a screws or anything...do i have to open up the door panel or what? thanx

recently(staring abot a month and a half ago) i started noticing a clunk when acclerating and declerating. also when at a speed and you punch gas and let off a loud thump is heard. i though this was the u-joints but i checked them and didnt notice any problems. i have been sdriving it for a week...