mazda

Hey, I have recently bought a ford ranger with a supposed low mileage tranny swap.. it bust on us, so got a new tranny, replaced the clutch, slave cylinder, throw out bearing etc.. putting the tranny in.. got it all in place, 5 of the 6 tranny-engine bolts in place, except the very top passenger...

Just got this ride and put a new rotor, caliper and pads on my drivers side today. Something's definitely wrong… My ABS light came on and the pedal pushes back at my foot from time to time.. Any advise? Not really a mechanic but I'm definitely Handy.

I recently dropped my transmission to replace the clutch. I am usually very good about labeling my bolts, but idiot me piled all the tranny bolts (one-at-a-time) on the table. I then noticed, a day later, that there are 5 shorter bolts (appx. 2.75 inches in length) and 3 longer bolts (appx. 3.25...

I have a 97 mazda b4000 and replacing the tranny from an explorer. It all fits except the mazda tranny has 2 sensors on the top with 2 leads each. I can use you help in identifying what they are for . Here are some numbers that may help Original tranny p97GT-7006BBR Replacement tranny is...

I have a 93 Mazda Navajo 2WD I bought a few years ago and have been fixing it up. I bought a used transmission for it and 3rd+5th grind while in gear and is has no 4th at all. Can anyone give me an idea of whats going on with it? Thanks.

okay. so when i push the button it makes a clicking noise in the back left. but it doesnt actually go into 4h. can anyone help? please

This is the top view of the inside of the mass air flow sensor on a 2001 Mazda MPV. This part has 3 elemets.

This is the inside of the mass air flow sensor on a 2001 Mazda MPV. This part has 3 elemets.

94 Navajo LX. All stock for now (just got it), but it will soon have a small lift and 31s.