pan | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

pan

  1. 2

    4WD 5R55E Transmission Pan On 2WD 5R55E?

    Does the 4WD 5R55E deep pan bolt on to the 2WD 5R55E? I want to add a transmission fluid temperature sensor the next time I change my fluid. Any issues if I switch over to the deeper pan? I know I’ll have to use a longer filter too. I plan to use a pan with a drain bolt like this: Then...
  2. N

    Crap In oil pan HELP?? pics

    So I went to change the oil pan and gasket today and found some plastic and thin metal pieces in the pan. I dont know much about internals of an engine to know what they are and where to go from here. Also if I take the bits out and bolt it all back together would it be able to run till I have...
  3. T

    97 Explorer oil pump WOES!!!

    Hi fellas! It's been a long time since I've had to post regarding some sort of problem... Here's the deal: I have a 1997 Explorer (4.0L OHV) that my mother and stepdad gave me about a 1 1/2 yrs ago. When they gave it to me, they neglected to inform me that it has always had a clogged oil...
  4. L

    Valve body gasket.

    hi guys am new to this site, did alot of reading some time ago, about the 1997 explorer xlt, thought this is a very good place to get "knowledge" about this as ford decided they wanted to charge 4000 dollars for an overhaul, and 5000 for the timing redone, so i smiled and walked away with a dumb...
  5. Transmission pan gasket tear

    Transmission pan gasket tear

    Result of grossly overtightening my transmission pan bolts.
  6. Time to solder the nut to the pan.

    Time to solder the nut to the pan.

  7. The outside of the pan with the drain plug.

    The outside of the pan with the drain plug.

  8. The inside of the pan with the drain plug.

    The inside of the pan with the drain plug.

  9. Supplies for soldering a drain plug into a pan.

    Supplies for soldering a drain plug into a pan.

  10. Pan with the drill bit in place.

    Pan with the drill bit in place.

  11. Pan ready to be drilled.

    Pan ready to be drilled.

  12. Drill bit through the pan.

    Drill bit through the pan.

  13. Apply solder to the pan.

    Apply solder to the pan.

  14. A4LD pan without a drain plug.

    A4LD pan without a drain plug.

  15. 4 bottle drain pan with 4 separate valves.

    4 bottle drain pan with 4 separate valves.

Back
Top