removal

Okay i have been really frustrated by this. I have searched for a descent answer but now have come to this. How do you remove and then attach the wires from the passenger side upstream o2 sensor on this engine? I can see it, but for the life of me cannot get anywhere near it to disconnect it...

once everything is disconnected this should just lift straight up...right? This EGR tube is not moving...I know from reading the "Lower intake removal" sticky that there is a washer in there, but am afraid to snap the plastic plenum yanking on it. Wont budge. Any suggestions - I...

How Do I Remove The Lines? I Took The Clips Apart And The hoses I beleive Are crimped together im pulling all the ac parts off of a 96 to put on my 95 that someone sliced my ac lines on

Thanks to all who gave answers to my last question; the starting problem seems to be over now. Okay, I've done as much checking as I can in these forums and in my repair manuals and I have not seen this question answered: How do you remove the plastic trim on the top of the bumper for an Eddie...

Ok so i decided to remove my roof rack on my ex but i can figure out how to get to the bolts without shattering the roof racks. apparently whoever owned it before me already removed the cross bars or it was only for appearance and never had any but i can not figure them out and do not want to...

Thats probably the most stupid question you've read all year, but I've been repainting the wiper arms, wiper cowls and roof rack on my explorer tonight because they're severely faded and chipping... I get around to the rear wiper arm, and I thoouught there would just be a little tab I press...

Does anyone have pictures and/or instructions on how to remove the rear rotors of a 2000 Ford Explorer 4DOOR?! Any immediate help would be greatly appreciated THANK YOU!!!!!

Does anyone know how the carefully remove the stock radio? Pictures will help alot.

Here's the story. I let a buddy borrow my X to move his boat since his F150's trans took a dump. He scraped up against some rocks with that section of the bumper and tore off some of the the chrome plating, and now it looks like crap. I haven't gotten a chance to crawl under and look at it...

Are there any write ups on this? I want to take mine out so I can run all the wires for my system Pioneer P4000 Pioneer XM Radio Box Pioneer Bluetooth Box Any help would be Awsome! Thanks,

This website has a lot of pictures on removing the 3.0L engine from an Aerostar, and rebuilding it: http://www.webng.com/jthill/

Box is motor electric connection, circled is hole to be drilled-1/2", arrows are existing holes